Abstract:An indium‐doped zinc oxide (IZO) electron transport layer (ETL) is developed for high‐efficiency inverted organic solar cells, and indium doping can improve electron extraction and suppress charge recombination. A 1.2‐micrometer‐thick ultrathin flexible OSC achieves an efficiency of 17.0% with a power‐per‐weight ratio of 40.4 W g−1, which is one of the highest values among ultrathin flexible organic solar cells. Sol–gel processed zinc oxide (ZnO) is one of the most widely used electron transport layers (ETLs) in inverted organic solar cells (OSCs). The high annealing temperature (≈200 °C) required for sintering to ensure a high electron mobility however results in severe damage to flexible substrates. Thus, flexible organic solar cells based on sol–gel processed ZnO exhibit significantly lower efficiency than rigid devices. In this paper, an indium‐doping approach is developed to improve the optoelectronic properties of ZnO layers and reduce the required annealing temperature. Inverted OSCs based on In‐doped ZnO (IZO) exhibit a higher efficiency than those based on ZnO for a range of different active layer systems. For the PM6:L8‐BO system, the efficiency increases from 17.0% for the pristine ZnO‐based device to 17.8% for the IZO‐based device. The IZO‐based device with an active layer of PM6:L8‐BO:BTP‐eC9 exhibits an even higher efficiency of up to 18.1%. In addition, a 1.2‐micrometer‐thick inverted ultrathin flexible organic solar cell is fabricated based on the IZO ETL that achieves an efficiency of 17.0% with a power‐per‐weight ratio of 40.4 W g−1, which is one of the highest efficiency for ultrathin (less than 10 micrometers) flexible organic solar cells.

Solution-Processed ZnO with Conductivity over 1000 S Cm-1 for ITO-Free Organic Photovoltaics.

A Transparent Electrode Based on Solution-Processed ZnO for Organic Optoelectronic Devices

Enhancing performance of organic photovoltaic and photodetector devices using non-atomically doped ZnO electrodes with superior optical properties

Flexible Organic Photovoltaics from Zinc Oxide Nanowires Grown on Transparent and Conducting Single Walled Carbon Nanotube Thin Films

Indium-Doped Zinc Oxide Thin Films As Effective Anodes of Organic Photovoltaic Devices

Towards Transparent Conductive Zinc Oxide Films As Effective Anodes in Organic Photovoltaics

Enhanced Electron Transportation by Dye Doping in Very Low-Temperature (< 130 Degrees C)-Processed Sol-Gel ZnO Toward Flexible Organic Solar Cells

Delicate Energy-Level Adjustment and Interfacial Defect Passivation of ZnO Electron Transport Layers in Organic Solar Cells by Constructing ZnO/In Nanojunctions

Solution Processed ITO-free Organic Photovoltaic Devices

Solution-processed SnO(2 )nanoparticle Interfacial Layers for Efficient Electron Transport in ZnO-based Polymer Solar Cells

Highly conductive transparent organic electrodes with multilayer structures for rigid and flexible optoelectronics

Zinc As a New Dopant for NiOx-Based Planar Perovskite Solar Cells with Stable Efficiency Near 20%

ITO‐Free and Fully Solution‐Processed Semitransparent Organic Solar Cells with High Fill Factors

Ito-Free Organic Solar Cells with Oxide/Metal/Oxide Multilayer Structure Cathode

In‐Doped ZnO Electron Transport Layer for High‐Efficiency Ultrathin Flexible Organic Solar Cells

In‐Doped ZnO Electron Transport Layer for High‐Efficiency Ultrathin Flexible Organic Solar Cells (Adv. Sci. 37/2024)

Improvement of the Optoelectrical Properties of a Transparent Conductive Polymer via the Introduction of ITO Nanoparticles and Its Application in Crystalline Silicon/Organic Heterojunction Solar Cells

Impact of ZnO Photoluminescence on Organic Photovoltaic Performance

Low-Temperature Solution-Processed Zno Nanocrystalline Interfacial Layer with Antireflective Effect for Efficient Inverted Polymer Solar Cells

Efficient Organic Photovoltaics Using Solution-Processed, Annealing-Free TiO2 Nanocrystalline Particles As an Interface Modification Layer

High Mobility Indium Oxide Electron Transport Layer for an Efficient Charge Extraction and Optimized Nanomorphology in Organic Photovoltaics.