Abstract:Poly( 3,4-ethylenedioxythiophene) ( PEDOT) is usually dispersed in water by incorporating polystyrene sulfonate ( PSS) as a charge compensator and a template for polymerization. The polymerization behavior of 3,4-ethylenedioxythiophene (EDOT) without assistance of insulating PSS was explored. Due to their semiconducting and hydrophilic characteristics, pi-conjugated polyelectrolytes with sulfonic acid groups, namely PCPDT-T and PCPDT-2T, were used as template for in situ oxidative polymerization of PEDOT. The obtained PEDOT: polyelectrolyte composites showed good dispersibility in aqueous solution, which was used as hole transport layer (HTL) in polymer solar cells (PSCs). The morphologies and photoelectric properties of PEDOT:PSS and PEDOT:polyelectrolyte composites were characterized by Fourier transform infrared spectroscopy, ultraviolet-visible spectroscopy, ultraviolet photoelectron spectroscopy, atomic force microscopy, transmission electron microscopy and contact angle test, respectively. PEDOT:polyelectrolyte composites displayed suitable energy level, transmittance up to 95% (30 nm), hydrophobic surface morphology, as well as superior hole mobility, which were in favour of forming Omega contact with the active layer and increasing the injection and collection efficiency of the holes. Thus, improving the device photovoltaic performance. The current density-voltage (J-V) characteristics of the PSCs with the structure of Glass/ITO/HTL/PTB7-Th:PC71BM/PFN/Al were measured under one standard sun by solar simulator with an Air Mass 1.5 global (AM 1.5G) and an irradiation intensity of 100 mW/cm(2). Compared to the photovoltaic characteristics for PEDOT:PSS based device, PSCs with PEDOT:T (1:2) as HTL yielded the highest power conversion efficiency (PCE) of 8.6% with a short current density (J(SC)) of 18.07 mA/cm(2), open circuit voltage (V-OC) of 0.77 and fill factor (FF) of 61.31%, respectively. Compared to that of PEDOT:PSS, the obvious increased J(SC) for PEDOT:polyelectrolyte composites based PSCs was ascribed to the high hole mobility and transmittance, which were consistent with the results from the space-charge limited current (SCLC) method and the external quantum efficiency (EQE) measurement.

Improvement of the Optoelectrical Properties of a Transparent Conductive Polymer via the Introduction of ITO Nanoparticles and Its Application in Crystalline Silicon/Organic Heterojunction Solar Cells

High-Efficiency Silicon/Organic Heterojunction Solar Cells with Improved Junction Quality and Interface Passivation

High Conductivity PEDOT:PSS Thin Films Affording Improved Open Circuit Voltages in PEDOT:PSS-Si Heterojunction Solar Cells

Highly Conductive and Wettable PEDOT:PSS for Simple and Efficient Organic/c‐Si Planar Heterojunction Solar Cells

Conductivity Enhancement of PEDOT:PSS Film Via Sulfonic Acid Modification: Application As Transparent Electrode for ITO-free Polymer Solar Cells

High-Performance Polymer Solar Cells Realized by Regulating the Surface Properties of PEDOT:PSS Interlayer from Ionic Liquids.

Improving Performance of Organic-Silicon Heterojunction Solar Cells Based on Textured Surface Via Acid Processing

Study on the Fabrication of PEDOT:PSS/Si Hybrid Solar Cells Incorporated with F4TCNQ and VTMO

Research Progress in Improving the Performance of PEDOT:PSS/Micro- and Nano-textured Si Heterojunction for Hybrid Solar Cells

The Modified PEDOT:PSS As Cathode Interfacial Layer for Scalable Organic Solar Cells

Over 16.7% Efficiency Organic‐Silicon Heterojunction Solar Cells with Solution‐Processed Dopant‐Free Contacts for Both Polarities

Simple Solvent Treatment Enabled Improved PEDOT:PSS Performance Toward Highly Efficient Binary Organic Solar Cells

PEDOT:PSS-Nafion/n-Si Hybrid Heterojunction TOPCon Solar Cells: Experiment and Simulation

In situ Polymerization of PEDOT: pi-Conjugated Polyelectrolyte and Application as Hole Transport Layer in Polymer Solar Cells

Performance-Enhancing Approaches for PEDOT:PSS-Si Hybrid Solar Cells

Performance‐Enhancing Approaches for PEDOT:PSS‐Si Hybrid Solar Cells

Improving open-circuit voltage and short-circuit current of high-efficiency silicon-based planar heterojunction solar cells by combining V 2 O 5 with PEDOT:PSS

Improving Open-Circuit Voltage and Short-Circuit Current of High- Efficiency Silicon-Based Planar Heterojunction Solar Cells by Combining V2O5 with PEDOT:PSS

High Performance of PEDOT:PSS/n-Si Solar Cells Based on Textured Surface with AgNWs Electrodes

Phase Separation to Improve the Conductivity and Work Function of the PEDOT:PSS Solution for Silicon Hybrid Solar Cells

Improving the Organic/Si Heterojunction Hybrid Solar Cell Property by Optimizing Pedot:Pss Film and with Amorphous Silicon As Back Surface Field