Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

Preparation and Thermoelectric Properties of Doped Bi 2 Te 3 -Bi 2 Se 3 Solid Solutions

Preparation and thermoelectric properties of iodine-doped Bi2Te3-Bi2Se3 solid solutions

Preparation and Thermoelectric Properties of N -Type Bi 2 Te 2.7 Se 0.3 :D M

Thermoelectric Properties of I-doped Bi2Te2.85Se0.15 Solid Solutions

Preparation and Thermoelectric Properties of Bi 2 Te 3 -Bi 2 Se 3 Solid Solutions

Preparation and thermoelectric properties of Bi2Te3-Bi2Se3 solid solutions

Uniformity of Thermoelectric Properties of N-type Bi<sub>2</sub>Te<sub>3-y</sub>Se<sub>y</sub> Bulky Compacts

Thermoelectric properties of Bi 2 Te 3 -Bi 2 Se 3 solid solutions prepared by attrition milling and hot pressing

Effects of Nb doping on the thermoelectric performance of CuI doped n-type Bi2Te3

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals

Promoted thermoelectric performance of (Ag, Na) co-doped polycrystalline BiSe by optimizing the thermal and electrical transports simultaneously

Highly Enhanced Thermoelectric and Mechanical Properties of Bi-Sb-Te Compounds by Carrier Modulation and Microstructure Adjustment

Enhanced Thermoelectric Properties in Highly Co-Doped Bi2Se3 by Density-of-State Effective Mass Increase

High performance and low thermal conductivity in Bi<sub>2</sub>Se<sub>3</sub> induced by the synergistic regulation of a resonant energy level and microstructure prepared by Se slow-release method

Enhancement of thermoelectric properties over a wide temperature range by lattice disorder and chemical potential tuning in a (CuI) y (Bi2Te3)0.95- x (Bi2Se3) x (Bi2S3)0.05 quaternary system

Tunable Electrical Conductivity and Simultaneously Enhanced Thermoelectric and Mechanical Properties in n‐type Bi2Te3

First-principles study on doping and temperature dependence of thermoelectric property of Bi2S3 thermoelectric material

Transport Properties of Ni, Co, Fe, Mn Doped Cu0.01Bi2Te2.7Se0.3 for Thermoelectric Device Applications

Thermoelectric Performance of Mg2.2(Ge0.9Sn0.1) Ternary Solid Solution Doped with Ag, Bi, Ni and Sb

Effects of Bi and Sb Doping on the Thermoelectric Performance of N-Type Quaternary Mg2.18Ge0.1Si0.3Sn0.6 Materials

Enhanced Thermoelectric Performance of Bi–Se Co-Doped Cu 1.8 S via Carrier Concentration Regulation and Multiscale Phonon Scattering