Abstract:In the outdoor unit of a room air conditioner, the main factors that made it possible to vary the ability of cooling and heating are the development of BLDC motors, advances in inverter technology, and the development of refrigerant volume control technology. The main reason for this change in cooling and heating capacity is that it is possible to change the RPS of compressors. As the range of the compressor's RPS expands, so does the range of response to load variations. This is mainly based on the capacity of the high-pressure refrigerant produced by the compressor. When the compressor rotates at high speed or low speed, the difference in noise occurs depending on the difference in rotational speed. Of course, fans and motors also contribute to noise fluctuations, but the overall governing factor is the greater contribution of refrigerant from compressors and compressors. The refrigerant flows into the cycle configured in the outdoor unit and varies in speed and flow rate depending on the amount of refrigerant. This results in vibration and noise appearing in the form of radiations, resonances, solid sounds, resonances, and so on. There are several factors that can cause vibration or noise changes depending on the flow velocity and flow rate. In this paper, we selected reactance of compressor motors, mufflers directly connected to compressor discharge ports and accumulator at compressor inlet where fluid vibrations occur the most. First of all, reactance of motor responds quickly to load fluctuations and has a large instantaneous torque to instantaneous load fluctuations. The muffler, which is directly connected to the compressor discharge port, is the first Cavity where high-pressure gas meets, and can evaluate the concentration of kinetic energy that generates noise and improve the collection center to reduce fluctuating noise. The Accumulator is the part with the lowest temperature of refrigerant gas entering the compressor, and the rapid change in the flow path causes the most fluid to generate vibration and radiation of the structure. For this reason, we select three elements first. In this paper, we specifically describe the background of selecting three elements of an air conditioning outdoor unit for the variability of noise over RPS changes. We demonstrate that these factors can review the feasibility of the experiment, explain the results of the analysis, and possibility of reduce the variation noise.

VIBRATION-ACOUSTICS STUDY OF R410A ROTARY COMPRESSORS

Numerical Analysis of Noise Radiation from Refrigerator Compressor Shell

Investigation of Noise Characteristics of Electric Vibrator Utilizing Acoustic Camera and Transfer Path Analysis

Vibration and Noise Research on Oxygen Generator and Structural Optimization

Numerical Analysis Of Noise Radiation Of Compressor Shell Considering Lubrication Oil

The Inner Acoustic Field Variety Due to the Effect of Refrigerator Compressor Oil Based on Finite Element Analysis

Numerical analysis of the influence of lubrication oil on noise radiation of compressor shell

Acoustic Impedance Characteristics of Linear Compressors

Experimental and numerical study of high-intensity sound in the cavity between rotator and stator of high- pressure compressor

Acoustic power measurement of linear compressors

Experimental investigation on the vibration characteristics of the compressor in the outdoor unit of a household air conditioner

An Investigation of the Acoustic Enclosure of an Air Conditioning Compressor Using Response Surface Analysis and Topological Rigidity Optimization

Experimental studies of the vibro-acoustic characteristics of an axial piston pump under run-up and steady-state operating conditions

Vibration and pressure pulsation elimination in a reciprocating compressor suction system using an acoustic filter

Parameter study of Variation noise in outdoor of air conditioner

Performance Testing of Linear Compressors with Rc Approach

Vibration prediction and experimental validation of a rotary compressor based on multi-body dynamics

Control of noise generated from centrifugal refrigeration compressor

Visualization of vane chattering in rotary compressor{fr}Visualisation du cliquetis des aubes dans un compresseur rotatif

Experimental and Numerical Study on the Squeal of a Rotary Compressor

Analysis of high frequency noise sources on air conditioning variable speed compressors