Abstract:The centrifugal compressor is widely used for gas compression in various industrial fields such as aero-engine, gas turbine and turbocharger. However, the stable operating range is usually restricted by the occurrence of flow instability such as stall and surge. The paper experimentally examines the developing process of surge and stall occurring in a centrifugal compressor to advance the understanding on flow mechanism of flow instability. It is found that three types of pressure fluctuation can be observed at low flowrate region. At the critical point, the local stall firstly occurs in some specific diffuser passages and the enlarged local diffuser stall eventually induces the mild surge of compression system indicated by the sinusoidal pressure fluctuation. At lower mass flow rate, the diffuser stall cell begins to circumferentially propagate along the impeller rotating direction at 11% of rotor speed with the existence of mild surge. In comparative analysis of IGV pre-swirl angle on the occurrence of mild surge, the mild surge still occurs at the operating condition when the slope of the characteristic map of test stage is still obviously negative, in which the compression system is supposed to be stable in previous study. And a new suggested criterion for the prediction of mild surge is demonstrated that the occurrence of mild surge depends on the destabi-lization effect of downstream components about diffuser and volute. Combined with the experimental data, the streamwise distribution characteristic of diffuser stall can be used to develop the simplified model of lumped parameters for the analysis on the generation mechanism of the diffuser rotating stall. The quantitative investigation on the relation between the pressure-rise characteristic of subcomponents and the occurrence of mild surge and diffuser rotating stall not only advances the prediction of stability limit but also lays the theoretic foundation for controlling these unsteady behaviors to improve the operating range.

Experimental and Numerical Study on the Squeal of a Rotary Compressor

Numerical Analysis Of Noise Radiation Of Compressor Shell Considering Lubrication Oil

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Vibration Analysis of a Nonlinear Rotor-Bearing-seal System

Compressor Stability at Pulsating Condition Via Gas Dynamics Responses Analysis

Surge Process of a High-Speed Axial–Centrifugal Compressor

Dynamic Model and Numerical Simulation for Synchronal Rotary Compressor

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

Squeal Noise of Friction Material With Groove-Textured Surface: An Experimental and Numerical Analysis

Squeal Noise in Hydraulic Poppet Valves

Investigation of tip leakage flow unsteadiness and rotating instability in a centrifugal compressor impeller

Experimental and Numerical Investigation of Non-synchronous Blade Vibration Excitation in a Transonic Axial Compressor

Numerical Investigation on Rotating Instability in a Multistage Axial-Radial Combined Compressor

Experimental and numerical study of high-intensity sound in the cavity between rotator and stator of high- pressure compressor

Experimental Investigation on the Aerodynamic Instability Process of a High-Speed Axial-Centrifugal Compressor

Analysis, modeling and simulations of an innovative sliding vane rotary compressor with a rotating cylinder

Investigation of the Mild Surge in an Axial–centrifugal Compressor

Numerical Investigation On Pressure Fluctuations In Centrifugal Compressor With Different Inlet Guide Vanes Pre-Whirl Angles

Simulation research on aerodynamic noise characteristics of a compressor under different working conditions

Performance analysis for a rotary compressor at high speed: experimental study and mathematical modeling

Numerical investigation of the rotating instability uniqueness in a MWe scale supercritical carbon dioxide centrifugal compressor