Multilayer Gradient Rare Earth Disilicate Coating Prepared by In-Situ Melt Infiltration and Sintering Method with High Thermal Shock Resistance on Porous Si3N4 Ceramics

Xingyu Fan,Chengcheng Han,Yuting Zhang,Zhou Yang,Jie Dong,Qiushi Wang

DOI: https://doi.org/10.1016/j.jeurceramsoc.2023.05.018

IF: 5.7

2023-01-01

Journal of the European Ceramic Society

Abstract:Dense multilayer gradient rare earth disilicate (& gamma;-Y2Si2O7 /& beta;-Yb2Si2O7 /& beta;-Lu2Si2O7) coatings were in-situ pre-pared by melt-infiltration /sintering procedure on porous Si3N4 ceramics for water resistance. Experimental and numerical simulation methods were used to study their thermal shock behavior. As a control, thermal shock behavior of pure & gamma;-Y2Si2O7 coatings were also compared. FEM results showed that the gradient design of modulus in ceramic coating can effectively avoid the mismatch of mechanical properties between coating layer and in-ternal substrate, reducing the transient thermal stress in each layer during thermal shock. All of the pure & gamma;-Y2Si2O7 coatings were failed after thermal shock tests with & UDelta;T & AP;1200 celcius. However, when sintering temper-ature of multi-layer disilicate coatings were higher than 1400 celcius, the water absorption rates after thermal shock were all less than 5%, still showing good waterproof performance. The gradient design of modulus could effectively improve the structural stability of ceramic coatings.