Abstract:Ductile crack growth plays an important role in the analysis of the fracture behavior of structures. Crack-like defects in pipe systems often develop during fabrication or in-service operation. The standard single edge notched bending (SENB) specimen with crack depth of a/W = 0.5 has a significantly higher geometry constraint than actual pipes with circumferential surface cracks, which therefore introduces a high degree of conservatism in engineering critical assessment (ECA) of pipes. Moreover, it is difficult to know how conservative the results are, because the geometry constraint is highly material-dependent. For circumferential surface flaws in pipes, the single edge notched tension (SENT) specimen has frequently been used because it has a geometry constraint in front of the crack tip that is similar to the cracks in pipes. Much work has been carried out on tensile testing for the SENT specimen as an alternative fracture mechanics specimen of pipes. In studying fully circumferential cracks in pipes, the crack geometry, applied load and boundary conditions are symmetrical about the axis of revolution. A typical radial plane containing the axis of rotational symmetry can represent these axisymmetric bodies; therefore the three-dimensional analysis can be reduced to a two-dimensional problem. This work systemically applies 2D axisymmetric models to study the ductile crack growth behavior of pipes with fully internal and external circumferential cracks under large scale yielding conditions. The complete Gurson model (CGM) developed and implemented by Zhang was utilized to predict the ductile crack growth resistance curves. Pipes with various internal pressure, diameter-to-thickness ratios, crack depths and material properties, as denoted by hardening and initial void volume fraction, have been analyzed. The results have been compared with those of corresponding clamped-loaded SENT (with same crack depth) and standard SENB specimens. It clearly indicates that the SENT specimen is a good representation of circumferentially flawed pipes and an alternative to the conventional standard SENB specimen for the fracture mechanics testing in ECA of pipes.

Double-walled Pipe Preparation by Tensile Method and Experimental Verification of Safety

Experimental study and capacity analysis of double-tapered rectangular steel tubes

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

Stress analysis of double-walled pipes undergone mechanical drawing process

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Safety Test Research of Pressure Pipes Containing Incomplete Welding Defects

Safety Testing and Analysis of the Header of the Drawn Boiler with a Small Diameter and a Large Wall Thickness

EXPERIMENT AND DESIGN OF DOUBLE SKINNED CONCRETE|FILLED STEEL TUBES

Effect of Post-Weld Heat Treatment on the Plastic Buckling of Welded Cylindrical Shells

Experimental and Fea Investigations on the Fracture Properties of Pipe Structures under Internal Pressure in Dbtt Region

Investigation on axial deformation of high strain line pipe

Thermal, metallurgical and mechanical analysis of circumferentially multi-pass welded P92 steel pipes

Experimental study on the compression mechanical behaviour of steel pipes with mechanically induced pitting corrosion

Numerical Simulation and Experimental Confirmation of a Bimetallic Pipe Forming Process

Investigation of the tensile strain response of the girth weld of high-strength steel pipeline

Fracture behavior analysis of X80 pipelines welded joints with unequal wall thickness

Constraint Effect on the Ductile Crack Growth Resistance of Circumferentially Cracked Pipes

The research on the critical loading path of thick-walled pipes under external pressure and cyclic bending

Experimental and Numerical Evaluation on Deformation and Fracture Mechanism of Cast Duplex Stainless Steel Tubular Specimen

Strain Based Design Of High Strength Pipelines

Failure Experiments on Pipes with Local Wall Thinning Subjected to Multi-Axial Loads