Abstract:Numerical simulations of the cutting process play a key role in manufacturing and cost optimization. Inherent in finite element analysis (FEA) simulations is the correct description of material behavior during machining. For this purpose, various material models are used to describe the behavior of the material in the range of high deformation, high temperature values, and high strain rates. Very often the Johnson–Cook (JC) material model is used for this purpose; however, the correct determination of the material constants of this model is a key aspect. Therefore, this paper presents a procedure for determining the material constants of the JC model using an analytical method based on normalized tensile and compression testing of the material for different strain rates over a wide temperature range. After determining the material constants, the authors conducted numerical simulations of the orthogonal turning of Ti6Al4V titanium alloy using the obtained constants. Validation of the obtained results with those obtained in experimental studies was also carried out. The outcomes demonstrated that the difference between FEM simulation and experimental tests did not exceed 0.02 mm (14%) in the case of chip thickness,. Much smaller differences were obtained for the temperature in the cutting zone, where the maximum difference was about 45 °C (4%). Comparing the components of the cutting force, we found that, in the case of the main cutting force, in most cases, the differences did not exceed 70 N (8%). After the verification of the obtained results, it was also found that the determined material constants of the Johnson–Cook model can be successfully used in FEM modeling of the cutting process of Ti6Al4V titanium alloy for the adopted range of values of technological parameters.

Experiment and Numerical Simulation on Cross-Die Forming of SUS304 Metastable Austenitic Stainless Using a Modified Johnson-Cook Model

A Method for Prediction of Forming Strain for Cold Stamping Formed Head Made of S30408 Austenitic Stainless Steel

Numerical Simulation of Microstamping Process to Fabricate Multi-channel of SUS304 Thin Sheets with Consideration of Grain Structures

Numerical simulation and experimental validation of microstructure evolution during the upsetting process of a large size martensitic stainless steel forging

Study on constitutive relationship of 6061 aluminum alloy based on Johnson-Cook model

A modified Johnson-Cook model considering strain softening of A356 alloy

Experimental Determination and Simulation Validation: Johnson–Cook Model Parameters and Grinding Simulation of 06Cr18Ni11Ti Stainless Steel Welds

Research on inverse identification of Johnson-Cook constitutive parameters for turning 304 stainless steel based on coupling simulation

A Modified Johnson-Cook Model for 10%cr Steel at Elevated Temperatures and a Wide Range of Strain Rates

Parameter identification of Johnson-Cook constitutive model based on genetic algorithm and simulation analysis for 304 stainless steel

Quantitative analysis of strength and plasticity of a 304 stainless steel based on the stress-strain curve

Finite element simulation of residual stress in machining of Ti-6Al-4V with a microstructural consideration

Dynamic Mechanical Behavior and Constitutive Model of Stainless Steel

Modification of strain rate strengthening coefficient for Johnson-Cook constitutive model of Ti6Al4V alloy

Determination and Verification of the Johnson–Cook Constitutive Model Parameters in the Precision Machining of Ti6Al4V Alloy

Stress-Strain Curves and Modified Material Constitutive Model for Ti-6Al-4V over the Wide Ranges of Strain Rate and Temperature

Experimental Development of Johnson–Cook Strength Model for Different Carbon Steel Grades and Application for Single‐Pass Hot Rolling

Numerical simulation and experimental analysis of solid-state sintering response of 316 L stainless steel micro-parts manufactured by metal injection molding

Modification of the Johnson-Cook relationship for AZ31 magnesium alloy at high strain rates

Modified Johnson-Cook Constitutive Model for Dynamic Compressive Behaviors of C250 Maraging Steel at Different Temperatures

Phenomenological Modeling of Deformation-Induced Martensite Transformation Kinetics in Austenitic Stainless Steels