Abstract:The low Seebeck coefficient and the high thermal conductivity deteriorate the thermoelectric properties of GeTe. Herein, the Seebeck coefficient is enhanced by promoting band convergency induced by the strongly correlated d, f electrons of rare earth elements. The doping of Pb and Bi causes avoided crossing and hierarchical structure, strengthening the full‐spectrum scattering of phonons and decelerating the sound velocity. As a highly promising thermoelectric material in the mid‐temperature region, pristine GeTe shows deteriorated thermoelectric properties due to the low Seebeck coefficient and the intrinsic high thermal conductivity. Herein, it is discovered that the introduction of strongly correlated d, f electrons by alloying rare‐earth atoms at Ge sites will increase the band effective mass and promote band convergency, which can largely improve the electric transport property. Moreover, the heavy atoms (Pb, Bi) doping induces optical phonon softening and the avoided crossing between acoustic and optical phonon branches, decelerating both optical and acoustic phonon velocities. The modulated composition wave from the fluctuated multi‐component distribution introduces a complicated hierarchical structure including point defects and nanoprecipitates, which provides all‐scale scattering sources for heat‐carrying phonons and results in low lattice thermal conductivity. Consequently, a high zT of 2.4 at 800 K can be obtained in the Ge0.86Pb0.09Bi0.03Ce0.005Te sample due to the combination of strong correlation for d, f electrons and the full‐spectrum scattering for phonons. This work provides an effective strategy to increase the thermoelectric performance of IV–VI compounds by combining the modulated band structure and the softening phonon dispersion.

Effect of Thermal History on the Properties of Efficient Thermoelectric Alloys Ge0.86Pb0.1Bi0.04Te

Influence of Ag2te Doping on the Thermoelectric Properties of P-Type Bi0.5sb1.5te3 Bulk Alloys

Influence of Ag_2Te Doping on the Thermoelectric Properties of p-type Bi_(0.5)Sb_(1.5)Te_3 Bulk Alloys

Regulation of exciton for high thermoelectric performance in (Bi, Sb)2Te3 alloys via doping with Pb and multi-scale microstructure

Relating Local Structure to Thermoelectric Properties in Pb1-x Ge X Bi2Te4

Thermoelectric Properties of Ag Doped Pseudo-binary Alloys (PbTe)1-x(SnTe)x

Modulating the Valence of Ga and the Deep Level Impurity for High Thermoelectric Performance of N-Type Pb0.98Ga0.02Te1-xSex Compounds

Achieving High-Performance Ge<sub>0.92</sub>Bi<sub>0.08</sub>Te Thermoelectrics via LaB<sub>6</sub>-Alloying-Induced Band Engineering and Multi-Scale Structure Manipulation

Enhanced Thermoelectric Performance in High Entropy Alloys Sn0.25Pb0.25Mn0.25Ge0.25Te

Realizing High Thermoelectric Performance in GeTe‐Based Supersaturated Solid Solutions

Near-room-temperature rhombohedral Ge1-Pb Te thermoelectrics

Enhanced Thermoelectric Performance in High Entropy Alloys Sn 0.25 Pb 0.25 Mn 0.25 Ge 0.25 Te

Thermoelectric properties of Na-doped PbTe0 .8-xSe0 .2 Sx alloys

Achieving High‐Performance Ge 0.92 Bi 0.08 Te Thermoelectrics via LaB 6 ‐Alloying‐Induced Band Engineering and Multi‐Scale Structure Manipulation

Improvement of the thermoelectric properties of GeTe- and SnTe-based semiconductors aided by the engineering based on phase diagram

Enhancing Near-Room-Temperature GeTe Thermoelectrics through In/Pb Co-doping

Thermoelectric Properties of Hydrothermal Synthesized Bi-Te-Se Alloys

Melt-slow Cooling Synthesis and Thermoelectric Properties of Pb9.6SbmTe3Se7 Alloys

Evaluation on the Thermoelectric Cooling Ability of PbTe

Enhancing thermoelectric performance in GeTe through Ge enrichment regulation and AgCuTe alloying

Thermoelectric Properties of Single Crystals of a Pb-Enriched Pb0.75Sn0.25Te Solid Solution