Abstract:PLL frequency synthesizers with low jitter are essential for mm-Wave high-speed wireless communication systems and data converters. By doing away with the frequency doubler, low jitter synthesizers with the 2 ND harmonic output can simplify their architecture. Additionally, to produce high-quality local oscillator signals for 2ND harmonic output, it is beneficial to suppress the fundamental frequency component at 2 ND harmonic output. In general, lowering the voltagecontrolled oscillator's phase noise (PN) and reducing the PLL's bandwidth to suppress in-band noise are the two most popular ways to minimize PN of PLL. The phase noise of N-core VCO reduce PN by 10logN, which is an effective method for obtaining low PN. Additionally, increasing the reference clock frequency hence decreasing the loop frequency division ratio can decrease PN. Literature [1] used a reference clock frequency of 500MHz with 175mW to implement the PLL of 52-fs <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">rms</inf> Jitter. Ref. [2] adopted a folded transformer-based series resonance CMOS VCO, the PN of which achieved -130.8dBc/Hz@1MHz, consumed 242mW while reducing the core area. Ref. [3] uses a clock frequency of 250MHz to reduce the overall contribution of VCO through wideband PLL, while suppressing the noise introduced by the reference clock through the design of double-sampling phase detector (SPD). Ref. [4] uses the high gain of phase-frequency detector (PFD) with time amplification to suppress the gain of CP, thus achieving the performance of 60-fs <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">rms</inf> Jitter. This study presents the construction of a PLL based on a 4-core resistance-synchronized VCO that achieves 47-fs <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">rms</inf> Jitter and produces 2 ND harmonic with fundamental frequency suppression.

A Method to Reduce Jitter Due to Power Noise by Optimizing Loop Filter in PLL Based Clock Source

Switched-loop filter for automatically frequency-calibrated phase-locked loops

Optimized System Design for Fully Integrated Fractional-N Pll

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A Low Power PLL Circuit with Area-Saving Loop Filter Applied in MEMS

Power And Jitter Optimized Vco Design Using An On-Chip Supply Noise Monitoring Circuit

A Low Power Sub-GHz PLL with Optimized LO Distribution Circuit

A 0.8 V Low Power Low Phase-Noise Pll

A Design Optimization Method for Low Jitter Clock PLLs

Design and simulation optimization of phase-locked loop structure for phase-shifting power supply

Low Jitter and Low Power PLL : Towards the Utopia

Jitter Analysis and a Benchmarking Figure-of-Merit for Phase-Locked Loops

IEEE ASSCC 2023/ Session 10/ Paper 10.5.

Design Of Low-Jitter 1-Ghz Phase-Locked Loops For Digital Clock Generation

Analysis and Design of a Sub-Sampling PLL of Low Phase Noise and Low Reference Spur

A 4.7ghz Synchronized-Multi-Reference PLL with In-Band Phase Noise Lower Than Reference Phase $\text{noise +20}\Text{logn}_{\mathrm{d}\mathrm{i}\mathrm{v}}$

Jitter-Power Minimization of Digital Frequency Synthesis Architectures

Optimization of Frequency Jittering Parameters for Conducted EMI Suppression in Switching Mode Power Supplies

An FIR-Embedded Noise Filtering Method for $\delta \sigma$ Fractional-N PLL Clock Generators

A Dual-Loop Injection-Locked PLL with All-Digital Background Calibration System for On-Chip Clock Generation

A 0.2-to-39.2ghz 66.2-Fs Jitter and −71.3dbc Spur Sub-Sampling PLL Using DAC-Based Constant Control Voltage Compensator and Quad-Mode 2nd Harmonic Filtering Oscillator