Abstract:The multilateration measurement acquires sufficient data for the identification of the position-independent geometric errors (PIGEs) and position-dependent geometric errors (PDGEs) of the rotary axis. However, because of redundancy in the used intermediate parameters, existing identification methods suffer from a loss of accuracy and precision caused by the relatively lower stability to the influences of random errors. Meanwhile, this may result in a more complicated process if additional constraints are added to reinforce stability. This paper proposes a non-redundant method for identifying both the PIGEs and PDGEs of the rotary axis. Firstly, the identification model, in which the rotating component pose errors are fully and non-redundantly described by the twists, is established to identify the pose errors caused by geometric errors. Then, by deriving the relationship between the pose error twists and the PIGE & PDGE parameters, the sequential decoupling algorithm applying the least squares condition, together with identification models, for both the PIGEs and PDGEs is developed. Comparative simulations and experiments are carried out. With no redundancy, the proposed method exhibits smaller discrepancies between the identified and preset test lengths in the cone path test simulation, yielding an average improvement of 15.73% and 56.97% in two identification modes, respectively. Furthermore, the method demonstrates smaller discrepancies between the predicted and measured test data in the cross-validation experiment with an average improvement of 80.21% and 86.87% in the two modes, respectively. These re-sults jointly verify the improvement in accuracy for identifying the PIGE and PDGE parameters. In addition, an overall reduction of the PIGE and PDGE uncertainties is observed in the Monte-Carlo simulations, which verifies the precision improvement.

A New Method for Evaluating the Accuracy of the Orientation Measured by Different Kikuchi Pole Combinations in Kikuchi Patterns

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

A New Method to Eliminate the Misalignment Angle in Dynamic Goniometer Based on Fiber Optic Gyro

A New Optical Angle Measurement and Compensation

Machining tests to identify kinematic errors of machine tool table rotation axis based on sensitive directions

Identifying rotational symmetry axes in Kikuchi patterns by reciprocal vectors

A new method for locating Kikuchi bands in electron backscatter diffraction patterns

Accuracy assessment of crystal orientation indexations by EBSD

Accurate Inner Profile Measurement of a High Aspect Ratio Aspheric Workpiece Using a Two-Probe Measuring System

Study on the Orientational Relationship Between Martensite Variants by EBSD

Non-redundant Identification of Geometric Errors in Multilateration of Rotary Axis

Three-Probe Error Separation with Chromatic Confocal Sensors for Roundness Measurement

Quantitative Analysis of the Crystallographic Orientation Relationship Between the Martensite and Austenite in Quenching–Partitioning–Tempering Steels

A Novel Experimental Method for Determining the Eigen-Axes Angle of MEMS Ring Gyroscope

A Method for Accurate Orientation Determination for Rotation Electron Diffraction Patterns

A new calibration method for parallel kinematics machine tools using orientation constraint

Error Correction for Rotationally Asymmetric Surface Deviation Testing Based on Rotational Shears

Normal direction measurement in robotic drilling and precision calculation

Correction of step size dependency in local misorientation obtained by EBSD measurements: Introducing equidistant local misorientation

A Measurement and Separation Method for Perpendicular Errors of Rotary Axes

Optimization Design for Normal Direction Measurement in Robotic Drilling