Abstract:An electrohydrostatic actuator (EHA) can be the most promising alternative compared with the traditional hydraulic servo actuators for its high power density, ease of maintenance, and reliability. As the core power unit that determines the performance and service life of the EHA, the motor-pump assembly should simultaneously possess a wide speed/pressure range and a high dynamic response. This paper presents a method to test the performance of the motor-pump assembly through simulation and experimentation. The flow output characteristics were defined through simulation and analysis of the assembly at the beginning of the experiment, leading to the conclusion of whether the pump could meet the requirements of the EHA. A series of performance tests were conducted on the motor-pump assembly via a pump test bench in the speed range of 1,450-9,000 rpm and the pressure range of 1-30 MPa. We tested the overall efficiency of the motor-pump assembly under various working conditions after confirming the consistency between the test results of the flow output characteristics with the simulation results. The results showed that the assembly has higher overall efficiency when working at 4,500-7,000 rpm under the pressure of 10-25 MPa and at 2,000-2,500 rpm under 5-15 MPa. Overall, this method can be utilized for determining in advance whether the motor-pump assembly meets the requirements of EHA. Moreover, this paper proposes a rapid test method of the motor-pump assembly in various working conditions, which could assist in predicting EHA performance.

Flow characteristics of integrated motor-pump assembly with phosphate ester medium for aerospace electro-hydrostatic actuators

Flow characteristics simulation and low-noise design of fuel piston pump

Modeling and Experimental Analysis of the Single-Shaft Coaxial Motor-Pump Assembly in Electrohydrostatic Actuators

A review of high-speed electro-hydrostatic actuator pumps in aerospace applications: Challenges and solutions

A 5-Phase Fault-Tolerant Brushless Permanent Magnet Motor Drive for an Aircraft Thin Wing Surface Actuator

Churning Losses Analysis on the Thermal-Hydraulic Model of a High-Speed Electro-Hydrostatic Actuator Pump

Fault-Tolerant Brushless DC Motor Drive for Electro-Hydrostatic Actuation System in Aerospace Application

Flow Match and Precision Motion Control of Asymmetric Electro-Hydrostatic Actuators with Complex External Force in Four-Quadrants

Effect of Piston-Slipper Assembly Mass Difference on the Cylinder Block Tilt in a High-Speed Electro-Hydrostatic Actuator Pump of Aircraft

Thermal-fluid-structure coupling analysis for valve plate friction pair of axial piston pump in electrohydrostatic actuator (EHA) of aircraft

Development of a large flow electro-hydrostatic actuator equipped with four magnetostrictive-actuated pumps

Modeling and Control of a Novel Electro-Hydrostatic Actuator with a Three-Ports Hydraulic Pump

Analysis of the Cylinder Block Tilting Inertia Moment and Its Effect on the Performance of High-Speed Electro-Hydrostatic Actuator Pumps of Aircraft

A Brushless DC motor design for an aircraft electro-hydraulic actuation system

Development of an Intelligent Electric Motor-Driven Pump with High Energy Efficiency

Effects of Splined Shaft Bending Rigidity on Cylinder Tilt Behaviour for High-Speed Electro-Hydrostatic Actuator Pumps

Effect of Surface Texture on Wear Reduction of the Tilting Cylinder and the Valve Plate for a High-Speed Electro-Hydrostatic Actuator Pump

Cumulative Thermal Coupling Modeling and Analysis of Oil-Immersed Motor-Pump Assembly for Electro-Hydrostatic Actuator

Experimental Study of an Insert and Its Influence on Churning Losses in a High-Speed Electro-Hydrostatic Actuator Pump of an Aircraft

Mechanical Efficiency of Cartridge Two-Dimensional (2D) Piston Pump for Electro-Hydrostatic Actuators

Spline Design for the Cylinder Block Within a High-Speed Electro-Hydrostatic Actuator Pump of Aircraft