Microstructure and Properties of 2Cr13-xMo Stainless Steels Fabricated by Direct Laser Deposition
Jing Liang,Ziyang Lin,Xiuyuan Yin,Suiyuan Chen,Changsheng Liu,Ruihong Chai,Hongwei Zhang,Guangquan Tang,Kun Tian
DOI: https://doi.org/10.1007/s12540-021-01035-1
IF: 3.451
2021-09-09
Metals and Materials International
Abstract:In this paper, 2Cr13 stainless steels with different Mo contents (x = 0 wt%, 0.5 wt%, 1.0 wt%, 1.5 wt%, 2.0 wt%) were fabricated by Direct Laser Deposition (DLD) technology. The effects of Mo element on the microstructure evolution and comprehensive properties such as corrosion resistance and wear resistance of 2Cr13 stainless steel were investigated in detail. The results showed that the microstructure for the DLD 2Cr13 stainless steel was mainly composed of martensite, ferrite, and a small amount of Mo2C and Cr23C6 carbides. With the content of Mo increased from 0.5 to 1.5 wt%, the martensitic microstructure was refined and more dispersed Mo2C and Cr23C6 carbides were formed. The average microhardness and corrosion resistance of the DLD 2Cr13-xMo were increased with the Mo content increased from 0 to 1.0 wt%, and then decreased when the Mo content exceeded 1.0 wt%. For the DLD 2Cr13-1.0 wt% Mo, the average microhardness reached up to 620 HV0.2, and the highest corrosion resistance (self-corrosion potential − 0.34 V) was obtained, in which the self-corrosion potential was 0.05 higher than that of DLD 2Cr13 stainless steel. The wear resistance of the DLD 2Cr13-xMo gradually increased with the increase of the Mo, the wear mass loss of DLD 2Cr13-xMo (x = 1.0 wt%) was only 37% that of DLD 2Cr13 stainless steel.Graphic Schematic diagram of DLD process and the microstructure, properties of 2Cr13 stainless steel with different Mo contents fabricated by DLD technology: (a)The DLD process diagram, (b)The changes of samples microstructure with different Mo contents. The fabrication process of 2Cr13 stainless steel with different Mo content by Direct Laser Deposition and the microstructure evolution process of samples with different Mo content are visually described in this graph. Fig. 1a illustrates in detail the DLD process design for sample preparation using FL-Dlight02-3000W semiconductor laser (maximum power 3000 W, spot size 4mm×4 mm). Fig. 1b shows that the microstructure in the DLD 2Cr13 stainless steel was mainly composed of martensite, ferrite, and a small amount carbides. Combined with the principle of DLD and the effect of Mo addition on microstructure, it is concluded that when Mo content is 1.0wt%, the martensite grain size is smaller, the lath is parallel and the growth direction is consistent, the content of ferrite and carbide is not much, which leads to the highest microhardness and the best corrosion resistance and wear resistance.
materials science, multidisciplinary,metallurgy & metallurgical engineering