Abstract:The thermoelectric generator (TEG) and thermoelectric cooler (TEC) are emerging technologies for efficient-clean energy conversion-utilization systems. TE element number arrangement greatly affects the performance of two-stage TEGs/TECs or TEG-TEC combined systems. In the present study an endeavor has been proposed for a novel TEG-TEC integrated system by replacing the two-stage TEG with two-separated single-stage TEGs. Similar temperatures were applied to TEGs and individual systems with discrete currents demonstrates better performance than that with current connected in series. Corresponding multi-parameter and multi-objective optimization approach have been applied to automatically estimating the optimal structure. It has been witnessed that the separated systems can directly adjust the currents I1 and I2 to upsurge the Peltier cooling of upper stage. Therefore, the separated design is capable of overcoming the inverted pyramid structure restriction of traditional multi-stage TECs, which makes it feasible for the TECs fabrication. The multi-objective optimization, QL-C escalates by 35.33% for Max-QL-C-design, and COP increases by 467.35% for Max-COP-design. As a trade-off solution, QL-C and COP in TOPSIS-design respectively increase by 23.37% and 248.98%. The corresponding mechanisms of the optimized designs have been clearly discussed from the physical points of view. Therefore, the results of this research study will definitely expand the application opportunities of TECs to remote or special areas where power supply is not available.

Performance Optimization for a Novel Two-Stage Thermoelectric Generator with Different Pcms Embedding Modes

Numerical investigation of heat transfer mechanism in an embedded PCM-TEG for better overall performance under the fluctuating heat source

Optimized output electricity of thermoelectric generators by matching phase change material and thermoelectric material for intermittent heat sources

Enhancing the performance of TEG system coupled with PCMs by regulating the interfacial thermal conduction

Thermal management of a flexible controlled thermoelectric energy conversion-utilization system using a multi-objective optimization

Integration of thermal insulation and thermoelectric conversion embedded with phase change materials

Heat transfer mechanism and structure design of phase change materials to improve thermoelectric device performance

Experimental investigation on the influence of phase change material on the output performance of thermoelectric generator

Performance analysis of a novel Two-stage automobile thermoelectric generator with the Temperature-dependent materials

Enhanced Thermal Performance of a Thermoelectric Generator with Phase Change Materials

Comprehensive Performance Prediction and Power Promotion for Wearable Thermoelectric Generator with Flexible Encapsulation in Practical Application

Comparison and Parameter Optimization of A Two-Stage Thermoelectric Generator Using High Temperature Exhaust of Internal Combustion Engine

A Novel Optimization Method for TEG System Performance Based on Temperature and Heat Flux

Optimization of Length Ratio in Segmented Thermoelectric Generators for Engine's Waste Heat Recovery

Optimization of Thermoelectric Generator (TEG) Integrated with Three-Way Catalytic Converter (TWC) for Harvesting Engine's Exhaust Waste Heat

Performance optimization of a class of combined thermoelectric heating devices

Performance Investigation and Optimization of an L-type Thermoelectric Generator

An Optimization Study of Structural Size of Parameterized Thermoelectric Generator Module on Performance

Geometry and stage number optimization of a concentrating solar multistage segmented thermoelectric generator by exploiting different optimization schemes

Performance Comparison of Single- and Multi-Stage Onboard Thermoelectric Generators and Stage Number Optimization at a Large Temperature Difference

Configuration Optimization of the Segmented Modules in an Exhaust-Based Thermoelectric Generator for Engine Waste Heat Recovery