Abstract:Using thermoelectric generators (TEGs) to recover waste heat is a potential technological approach. To achieve maximum thermoelectric conversion power, scale optimization of thermoelectric modules has been reported in previous studies. However, the results obtained were all based on numerical calculations, and the analytical solution could not be proven theoretically. Therefore, understanding of the internal mechanism of the structural optimization theory is limited. In addition, the relevant optimization results were based on a full-series circuit, and no structural optimization theory for other circuit types has been proposed. To fill this gap, this study adopts a method that combines theoretical derivation and numerical calculation. First, the analytical solution of the optimal scale is derived by taking the full series as an example, and the existence of an optimal structure of the thermoelectric modules is theoretically confirmed. Subsequently, the scale optimization performance of the thermoelectric structure based on different circuit structures was further analyzed, providing theoretical guidance for the optimization of the thermoelectric structure under different circuit connection modes. The results indicate that the optimal lengths for different circuit layouts are quite different, regardless of whether maximum total power or net power is used as the optimization objective. However, for convenience, the optimal length of the full-series circuit mode can be used to design a constant length for all types of multi-stage series circuit modes when the objective is to maximize the net power output. Using this method, the percentage deviation of the obtained power from its theoretical peak net power can be less than 0.6% for the example presented in this study.

Theoretical study on an integrated two-stage cascaded thermoelectric module operating with dual power sources

Optimization of A Trapezoid-Type Two-Stage Peltier Couples for Thermoelectric Cooling Applications

Simultaneous optimization of cooling temperature difference and efficiency for multi-stage thermoelectric device

Individualization of optimal operation currents for promoting multi-stage thermoelectric cooling

Thermal management of a flexible controlled thermoelectric energy conversion-utilization system using a multi-objective optimization

A high efficiency cascaded thermoelectric generation system with power balancing mechanism

Multiparameter optimization of the thermoelectric module under the constant heat flux condition

Analysis on optimal length scale of thermoelectric generators when using different circuit layouts

Thermoelectric Performance Evaluation and Optimization in a Concentric Annular Thermoelectric Generator under Different Cooling Methods

Maximum Efficient Power Performance Analysis and Multi-Objective Optimization of Two-Stage Thermoelectric Generators

Enhanced Energy Harvesting from Thermoelectric Modules: Strategic Manipulation of Element Quantity and Geometry for Optimized Power Output

Performance enhancement of a novel thermoelectric self-cooling system for electronic devices

Proposing a procedure for multi-objective optimization of cascade thermoelectric coolers to achieve maximum cooling capacity and COP

Experimental study of optimization of thermoelectric modules' number and layout for waste heat recovery

Multi-parameters Analysis and Optimization of a Typical Thermoelectric Cooler Based on the Dimensional Analysis and Experimental Validation

Performance evolution of thermoelectric modules under constant heat flux

A novel super-cooling enhancement method for a two-stage thermoelectric cooler using integrated triangular-square current pulses

Impact of internal connections and heat loss on simulated large-scale low-temperature thermoelectric generation system

A Device-to-Material Strategy Guiding the “Double-High” Thermoelectric Module

Performance analysis of a novel Two-stage automobile thermoelectric generator with the Temperature-dependent materials

Optimal Design and Multi-Parameter Sensitivity Analysis of a Segmented Thermoelectric Generator