Abstract:The membrane electrode assembly (MEA) of a proton exchange membrane fuel cell (PEMFC) would deform when there is a pressure difference between the cathode and anode. In this study, a three-dimensional PEMFC model that incorporates a two-dimensional MEA deformation model is employed to investigate the effects of the curved MEA on oxygen transport, liquid water removal, pressure drops across cells, and resulting overall cell performances. The results show that the MEA deformation generates a gap between the rib and gas diffusion layer (GDL), thereby enhancing the oxygen transport into and liquid water removal from the cathode porous electrode. At an operating voltage of 0.4 V, the output current density is enhanced by 4.83%, 6.67%, and 8.61%, respectively, for the pressure differences of 10, 20, and 30 kPa between the cathode and anode, as compared with that without a pressure difference. An efficiency evaluation criterion (EEC) that represents a tradeoff between mass transfer enhancement and pressure drop penalty is introduced to evaluate the overall cell performance enhancement. The result shows that the EEC value increases with increasing the pressure difference between the cathode and anode, confirming the performance enhancement by the deformed MEA. In addition, the effects of MEA deformation are also examined at two sets of channel heights (H) and widths (W), i.e., WH=0.5 mm and WH=1.5 mm. At an operating voltage of 0.4 V, the output current density is enhanced by 20.18% at a pressure difference of 30 kPa for the cell with WH=0.5 mm, whereas it is improved only by 2.91% for the cell with WH=1.5 mm. Therefore, increasing the pressure difference between the cathode and anode is a more effective approach to performance enhancement for the cell with a small channel height and width.

Study and Experimental Verification of the Effect of Assembly Pressure on the Electrical Efficiency of PEM Fuel Cells

Elucidating non-uniform assembling effect in large-scale PEM fuel cell by coupling mechanics and performance models

Study of Contact Pressure Distribution in Bolted Encapsulated Proton Exchange Membrane Fuel Cell Membrane Electrode Assembly

Influence of clamping pressure on contact pressure uniformity and electrical output performance of proton exchange membrane fuel cell

Investigation of the assembly for high-power proton exchange membrane fuel cell stacks through an efficient equivalent model

Modeling and performance investigation on the deformed gas diffusion layer of PEM fuel cell

Stress response and contact behavior of PEMFC during the assembly and working condition

Effect of design and operating pressure on the performance of a polymer electrolyte membrane-based cylindrical fuel cell

Sealing Performance of Ethylene Propylene Diene Monomer Seals for Proton Exchange Membrane Fuel Cells

Unmasking the reactants inhomogeneity in gas diffusion layer and the performances of PEMFC induced by assembly pressure

Reaction Gas Pressure, Temperature, and Membrane Water Content Modulate Electrochemical Process of a PEMFC: A Simulation Study

Study on the Effect of Membrane Electrode Assembly Parameters on Polymer Electrolyte Membrane Fuel Cell Performance by Galvanostatic Charging Method

The Performance Improvement of Membrane and Electrode Assembly in Open-Cathode Proton Exchange Membrane Fuel Cell

Study on water and oxygen transfer characteristics of HT-PEM fuel cells

Effect of Metallic Bipolar Plates Fillet Radii on Fuel Cell Performance

Performance investigation of proton exchange membrane fuel cells with curved membrane electrode assemblies caused by pressure differences between cathode and anode

Effects of Inhomogeneous Gas Diffusion Layer Properties on the Transportation Phenomenon and Performances of Proton-Exchange Membrane Fuel Cells

Better electrochemical performance of PEMFC under a novel pneumatic clamping mechanism

Clamping Pressure and Catalyst Distribution Analyses on PEMFC Performance Improvement

Numerical Study on Effect of Flow Field Configuration on Air-Breathing Proton Exchange Membrane Fuel Stacks

Review on proton exchange membrane fuel cell stack assembly: Quality evaluation, assembly method, contact behavior and process design