Abstract:The advantages of utilizing activated carbonate additions as a surplus provider of calcium were elucidated in this study. The pozzolanic activity inherent in clays and minerals containing carbonate can be tailored through the de‐hydroxylation of clay and the de‐carbonation of calcite content. Special consideration needs to be given to ensuring the effective activation of schist‐type materials, given the potential for substantial variations between the outcomes of laboratory‐scale and industrial‐scale activation processes for materials characterized by very low thermal conductivity, such as schists. Supplementary cementitious materials (SCMs) are partial substitutes for ordinary Portland cement (OPC) to reduce cost, the production of carbon dioxide (CO2), and fossil fuel consumption. Recent studies illustrated the effectiveness of calcined kaolinite clay as a proper partial replacement for OPC. Hence, schist‐type materials containing sufficient clay contents are regarded as promising candidates for OPC replacement. This study focuses on the possible use of activated calcium carbonates (CaCO3) to augment pozzolanic reactions of schists as a substitute for OPC. The use of activated calcium carbonates proved to be successful in expediting pozzolanic reactions and facilitating the formation of additional calcium aluminosilicate hydrate (C‐A‐S‐H). In this study, the optimal strength performance for blended cement was achieved by adjusting the total carbonate content to 30 wt.% of the schist. The decision to introduce carbonate to the schist was guided by calculations determining the need for an excess of calcium ions to fully harness the potential for C‐A‐S‐H formation. Virgin and augmented schists were activated by up to 80% of their respective potentials by heat treatment. Phase content and decomposition behavior of the active components were investigated by thermogravimetric analysis (TGA), x‐ray diffraction (XRD), and scanning electron microscopy (SEM). Cement paste samples incorporating 30 wt.% replacement of OPC with activated schist SCMs were prepared. The phase distribution and compressive strengths of these samples were assessed at hydration intervals of 2, 7, 28, 50, and 90 days. Cement formulations with activated calcium‐augmented SCMs exhibited compressive strength values at 109%, 101%, 96%, 95%, and 94% compared to pure cement paste at 2, 7, 28, 50, and 90 days, respectively. These values surpassed 90% of the compressive strength of pure OPC at equivalent hydration time points.

Revisiting Ancient Roman Cement: the Environmental-Friendly Cementitious Material Using Calcium Hydroxide-Sodium Sulfate-Calcined Clay

Understanding the Role of Calcium Silicate Slag in Sodium Carbonate-Activated Green Materials: Influence on Kinetics, Strength, and Efflorescence

Properties and Microstructures of 3D Printable Sulphoaluminate Cement Concrete Containing Industrial By-Products and Nano Clay

Influence of C–S–H seed and sodium sulfate on the hydration and strength of limestone calcined clay cement

Efficient Utilization of Waste Marine Clay for Fine Aggregate to Develop Sustainable and Cost-Effective Strain-Hardening Cement-Based Composites

The Synergistic Effect of Calcained Coal-Series Kaolinite and Limestone on the Hydration of Portland Cement

Recycled Excavation Soils as Sustainable Supplementary Cementitious Materials: Kaolinite Content and Performance Implications

Reuse of the soda sludge dealt with water washing as a supplementary material for the synthesis of clinker binders

Optimization of Ca/Si ratio in schists to enhance the pozzolanic supplementary cementitious material for OPC blending

Improving the Performance of Mortar under Carbonization Curing by Adjusting the Composition of Ternary Binders

Calcium-Based Binders in Concrete or Soil Stabilization: Challenges, Problems, and Calcined Clay as Partial Replacement to Produce Low-Carbon Cement

Global insights into micro-macro mechanisms and environmental implications of limestone calcined clay cement (LC3) for sustainable construction applications

Feasibility of Using New Sustainable Mineral Additions for the Manufacture of Eco-Cements

Synergistic Activation Mechanism and Long-Term Properties of a Solid Waste Cementitious Materials Based on Red Mud and Calcium Carbide Slag

The influence of two types of alkali activators on the microstructure and performance of supersulfated cement concrete: mitigating the strength and carbonation resistance

Sustainable modified pozzolanic supplementary cementitious materials based on natural zeolite, fly ash and silica fume

Study on the Properties and Hydration Mechanism of Calcium Carbide Residue-Based Low-Carbon Cementitious Materials

Production of an eco-friendly concrete by including high-volume zeolitic supplementary cementitious materials and quicklime

Study on the Influence of Thermoplastic Microcapsules on the Sulfate Resistance and Self-Healing Performance of Limestone Calcined Clay Cement Concrete

Recycling phosphogypsum as a sole calcium oxide source in calcium sulfoaluminate cement and its environmental effects

The role of low-quality calcined clay in enhancing the performance of cement mortar exposed to normal and aggressive media