Abstract:A two-step time-to-digital converter (TDC) is designed for the high-precision time measurement of the DIRC-like TOF (DTOF) detector at the Super Tau-Charm Facility (STCF). Extending the measurement range by Nutt's method, the TDC clock cycle is interpolated with two voltage-controlled tapped delay lines (TDL) connected by a dual-slope time amplifier (TA). By amplifying the residue from the first-step TDL-based interpolation with the TA and measuring it with the second TDL, the TDC resolution is significantly improved to sub-gate delay. Since the residue is extracted by a new method without the need of TA duplication or delay insertion, the TDC power consumption and conversion time are effectively reduced. By adopting the improved TA circuit into the TDC with a high gain, adjustable output offsets, and good linearity, the TDC measurement precision is guaranteed. In addition, a new DLL structure is proposed to stabilize the TDL against process, voltage, and temperature (PVT) variations with less power consumption. Benefiting from the proposed residue extraction method and DLL structure, the TDC exhibits low power consumption. To verify the TDC design, a prototype chip with two TDC channels is fabricated in GlobalFoundries (GF) 180 nm CMOS technology for performance evaluation. With a system clock of 150 MHz, it has a resolution (LSB) of 16.5 ps and a maximum sample rate of 6 MS/s. The differential nonlinearity (DNL) error ranges from - 0.98 LSB to 0.87 LSB and the integral nonlinearity error (INL) ranges from- 4.21 LSB to 2.83 LSB. With a bin-by-bin calibration method, the measured TDC precision is 12.1 ps on average within the 0-20 ns time interval measurement range. In addition, the TDC has low temperature sensitivity and does not require recalibration within a 20 C-degrees temperature range. Each TDC channel consumes 434 mu W power at 1 MS/s sample rate. The test results confirm that the proposed TDC can achieve high precision with a moderate sample rate and low power consumption without highly scaled technologies, which can meet the requirements of the DTOF detector at STCF.

A low-power DTOF image sensor with double-frame-multiplexing mode for long-range detection

A 16-Channel Analog CMOS SiPM with On-Chip Front-End for D-ToF LiDAR

Pulsed Light Time-of-flight Measurement Based on a Differential Hysteresis Timing Discrimination Method.

A CMOS Time-of-Flight Image Sensor with High Dynamic Range Digital Pixel

A Wide Dynamic Range Analog Front-End with Reconfigurable Transimpedance Amplifier for Direct ToF LiDAR

A Two-Tap Indirect Time-of-Flight CMOS Image Sensor With Pump Gate Modulator for Low-Power Applications

A 12 Ps Precision Two-Step Time-to-Digital Converter Consuming 434 $\mu$ W at 1 MS/s in 180 Nm CMOS with a Dual-Slope Time Amplifier

A Time-to-Amplitude Converter With High Impedance Switch Topology for Single-Photon Time-of-Flight Measurement

A 320x240 I-ToF CMOS Image Sensor with 2-Tap 5.6m Pixel and Mismatch-Nonlinearity Suppression

A 49.5 Μw Multichannel Time-to-Digital Converter with 2D/3D Imaging Fusion for APD LiDAR Sensors

FPGA Based Pico-second Time Measurement System for a DIRC-like TOF Detector

Simultaneous Multifrequency Demodulation for Single-Shot Multiple-Path ToF Imaging

An 8-Tap CMOS Lock-In Pixel Image Sensor for Short-Pulse Time-of-Flight Measurements

Picosecond Timing Electronics for a DIRC-Like Detector at the Super Tau-Charm Facility

Development of a High Performance Digital Silicon Photomultiplier (dSiPM) for ToF PET Imaging

A Linear Dynamic Range Receiver with Timing Discrimination for Pulsed TOF Imaging LADAR Application

Miniaturized time-correlated single-photon counting module for time-of-flight non-line-of-sight imaging applications

Optimized Design Of A Led-Array-Based Tof Range Imaging Sensor For Fast 3-D Shape Measurement

A Time-to-Digital Converter for Low-Power Consumption Single Slope Analog-to-Digital Converters in a High-Speed CMOS Image Sensor

Design of Time-to-Digital Converters for Time-Over-Threshold Measurement in Picosecond Timing Detectors

Low-cost FPGA-based multi-channel TDC with high resolution and density for time-of-flight detectors