Abstract:The application requirements of high frame rate CMOS image sensors (CIS) in the industry have not been satisfied due to the speed limitations in traditional single-slope and serial two-step analog-to-digital converters (ADCs). In this paper, a high-speed fully differential two-step ADC design method for CIS was proposed. The proposed method was based on differential ramp and time-to-digital conversion (TDC) technology. A parallel conversion mode was formed that is different from serial conversion, and the robustness of the system was ensured due to the existence of differential ramps. Aiming at the inconsistency between traditional TDC technology and single-slope ADC, a TDC technology based on level coding was proposed. The proposed technology achieves the TDC in the last clock cycle of analog-to-digital conversion, and realized a two-step conversion process at another level. This paper presents a complete circuit design, layout design, and test verification of the proposed design method based on the 55 nm 1P4M CMOS experimental platform. Under the design environment of the analog voltage of 3.3 V, the digital voltage of 1.2 V, the clock frequency of 100 MHz, and a dynamic input range of 1.6 V, this design was a 12-bit ADC with a conversion time of 480 ns, column-level power consumption of 62 μW, differential nonlinearity (DNL) of +0.6/−0.6 LSB, and integral nonlinearity (INL) of +1.2/−1.4 LSB. Furthermore, it achieved a signal-to-noise distortion ratio (SNDR) of 70.08 dB. The proposed design provided a large area array with a high frame rate, and compared with the existing advanced single-slope ADC, its conversion speed increased by more than 52%. It provides an effective solution for the implementation of high frame frequency CIS.

A CMOS Time-of-Flight Image Sensor with High Dynamic Range Digital Pixel

An Arithmetic of Enhancing Dynamic Range of CMOS Image Sensor

A Cmos Image Sensor For Monochromatic Spectrum Imaging

A 16-Channel Analog CMOS SiPM with On-Chip Front-End for D-ToF LiDAR

Novel CMOS image sensor with a 132-dB dynamic range

An 8-Tap CMOS Lock-In Pixel Image Sensor for Short-Pulse Time-of-Flight Measurements

A Two-Tap Indirect Time-of-Flight CMOS Image Sensor With Pump Gate Modulator for Low-Power Applications

An Over 140 dB Dynamic Range CMOS Image Sensor Combined DCG and Logarithmic Response

320×240 Pixels CMOS Digital Image Sensor with Wide Dynamic Range

A 3.0 µm Pixels and 1.5 µm Pixels Combined Complementary Metal-Oxide Semiconductor Image Sensor for High Dynamic Range Vision beyond 106 dB

A Time-to-Amplitude Converter With High Impedance Switch Topology for Single-Photon Time-of-Flight Measurement

A Low-Noise CMOS Image Sensor With Digital Correlated Multiple Sampling

A Dual-Mode CMOS Image Sensor Based on In-Pixel Frame Differencing

Megapixel time-gated SPAD image sensor for 2D and 3D imaging applications

A 2.72 μ s row conversion time 11‐bit column‐parallel single‐slope analog to digital converter with differential‐clocks‐assisted time to digital converter interpolation for complementary metal oxide semiconductors image sensor

Low-light-level CMOS imaging sensor with CTIA and digital correlated double sampling

A Time-to-Digital Converter for Low-Power Consumption Single Slope Analog-to-Digital Converters in a High-Speed CMOS Image Sensor

A CMOS SPAD Sensor With a Multi-Event Folded Flash Time-to-Digital Converter for Ultra-Fast Optical Transient Capture

A 13-Bit, 12-ps Resolution Vernier Time-to-Digital Converter Based on Dual Delay-Rings for SPAD Image Sensor

High-Speed Fully Differential Two-Step ADC Design Method for CMOS Image Sensor

Simulations and Design of a Single-Photon CMOS Imaging Pixel Using Multiple Non-Destructive Signal Sampling