Abstract:The production of hydrogen via photoelectrochemical (PEC) water splitting using III-V semiconductors as photoelectrodes is a field of current research and challenges in materials science. Under PEC conditions relevant to water splitting, III-V semiconductors are prone to corrosion and suffer from corrosion-related decrease of efficiency, which so far impedes long-term usage of III-V semiconductor-based photoelectrodes. Gallium phosphide (GaP) has an indirect band gap of 2.26 eV which covers both the hydrogen evolution potential (HEP) and the oxygen evolution potential (OEP). Thus, in principal, GaP can be used both as photocathode and photoanode. Notwithstanding the favorable band gap energy, the use of GaP photoelectrodes for the photolysis of water has so far not been successful without applying an additional bias potential. In this contribution we demonstrate that, by specific surface conditioning, we are able to control and optimize the photoelectrochemical surface properties of photoanodes prepared from n-doped GaP(100) for PEC water splitting. We have studied the structural and chemical surface modifications of such photoanodes before and after extended PEC processes by scanning electron microscopy (SEM), atomic force microscopy (AFM), Auger electron spectroscopy (AES) and X-ray photoelectron spectroscopy (XPS). An approximately (2±1) nm thin oxide film is produced at the surface of n-GaP(100) via oxidizing the surface at 0.8 V vs RHE (reversible hydrogen electrode) and subsequent hydrogen evolution at very cathodic potentials. The latter step is crucial for a substantial reduction of the potential for water splitting, presumably because the evolved hydrogen passivates electrically active defects in the oxide film. After appropriate surface conditioning, photolytic water splitting was observed without applied voltage or addition of catalysts, as confirmed by detection of hydrogen gas evolving at the Pt counter cathode with a gas spectrometer. The n-GaP(100) photoanode was exposed to high-intensity illumination (120 mW/cm 2 ) at 0 V vs RHE in 0.02 M HCl electrolyte for a duration of 3 days while yielding stable photocurrents. Ex-situ surface characterization of the n-GaP(100) photoanodes was carried out after extended PEC water splitting. AFM revealed a very flat surface, and no signs of corrosion were observed even after extended periods of water splitting. AES depth profiles showed that phosphorous was depleted near the surface of the n-GaP(100) photoanode. Using AES spectra, the thickness of the oxide film was estimated. XPS measurements revealed that the surface oxide consists mainly of Ga 2 O 3 , while small concentrations of GaPO 4 , P 2 O 5 and also metal-like Ga are also present at the topmost surface layers of the n-GaP(100) photoanode. Electrochemical impedance spectroscopy (EIS) was carried out to understand the charge transfer processes across the semiconductor/electrolyte interface. Our EIS results suggest that defect states in the surface oxide and metal-like Ga at the very surface in contact with the electrolyte play crucial roles in the effective charge transfer across the semiconductor-electrolyte interface. Our surface conditioning processes lead to the formation of a nonporous, thin and stable Ga surface oxide which inhibits PEC surface corrosion and, at the same time, subserves the water splitting process.

Kinetically Versus Thermodynamically Controlled Factors Governing Elementary Pathways of GaP(111) Surface Oxidation

Oxidation State of GaP Photoelectrode Surfaces under Electrochemical Conditions for Photocatalytic CO2 Reduction

Atomic Layer-By-Layer Oxidation Of Ge (100) And (111) Surfaces By Plasma Post Oxidation Of Al2o3/Ge Structures

Tuning Intermediate Bands of Protective Coatings to Reach the Bulk‐Recombination Limit of Stable Water‐Oxidation GaP Photoanodes

Photolytic Water Splitting By Surface-Conditioned n-Gallium Phosphide(100) Photoanodes

Cover Feature: Elaborated Reaction Pathway of Photothermal Catalytic CO2 Conversion with H2O on Gallium Oxide‐Decorated and ‐defective Surfaces (chem. Eur. J. 24/2022)

Oxidation of GaN: An ab initio thermodynamic approach

Evolution of Surface Oxidation on Ta3N5 As Probed by a Photoelectrochemical Method

Surface oxidation of transition metal sulfide and phosphide nanomaterials

CO2 Photoreduction Via Quantum Tunneling: Thin TiO2-Coated GaP with Coherent Interface to Achieve Electron Tunneling

Synchrotron radiation photoemission study of potassium-promoted oxidation of InP(100) surface

Electrical and Optical Properties of G-Gan/al0.5ga0.5n 2D/3D Heterojunction under Surface Oxidation Via First-Principles

Operando Studies Redirect Spatiotemporal Restructuration of Model Coordinated Oxides in Electrochemical Oxidation

Photoemission study and band alignment of GaN passivation layers on GaInP heterointerface

Electrical and optical properties of g-GaN/Al 0.5 Ga 0.5 N 2D/3D heterojunction under surface oxidation via first-principles

Combined Ambient Pressure Xps, High Pressure Stm, And Dft Study Of The In Situ Oxidation Of Pt(110) And The Reaction Of Gas Phase Co With Two Distinct Surface Oxygen Species

In situ X-ray photoelectron spectroscopy of model catalysts: At the edge of the gap

Crystal-Structure-Dependent Photocatalytic Redox Activity and Reaction Pathways over Ga 2 O 3 Polymorphs

CO2 Photoelectrochemical Reduction Catalyzed by a GaP(001) Photoelectrode

Unveiling the role of surface P–O group in P-doped Co3O4 for electrocatalytic oxygen evolution by On-chip micro-device

Correlating Surface Crystal Orientation and Gas Kinetics in Perovskite Oxide Electrodes