Abstract:Temperature-programmed reaction spectroscopy (TPRS) and direct, isothermal reaction-rate measurements were employed to investigate the oxidation of CO on Pt(111) covered with high concentrations of atomic oxygen. The TPRS results show that oxygen atoms chemisorbed on Pt(111) at coverages just above 0.25 ML (monolayers) are reactive toward coadsorbed CO, producing CO(2) at about 295 K. The uptake of CO on Pt(111) is found to decrease with increasing oxygen coverage beyond 0.25 ML and becomes immeasurable at a surface temperature of 100 K when Pt(111) is partially covered with Pt oxide domains at oxygen coverages above 1.5 ML. The rate of CO oxidation measured as a function of CO beam exposure to the surface exhibits a nearly linear increase toward a maximum for initial oxygen coverages between 0.25 and 0.50 ML and constant surface temperatures between 300 and 500 K. At a fixed CO incident flux, the time required to reach the maximum reaction rate increases as the initial oxygen coverage is increased to 0.50 ML. A time lag prior to the reaction-rate maximum is also observed when Pt oxide domains are present on the surface, but the reaction rate increases more slowly with CO exposure and much longer time lags are observed, indicating that the oxide phase is less reactive toward CO than are chemisorbed oxygen atoms on Pt(111). On the partially oxidized surface, the CO exposure needed to reach the rate maximum increases significantly with increases in both the initial oxygen coverage and the surface temperature. A kinetic model is developed that reproduces the qualitative dependence of the CO oxidation rate on the atomic oxygen coverage and the surface temperature. The model assumes that CO chemisorption and reaction occur only on regions of the surface covered by chemisorbed oxygen atoms and describes the CO chemisorption probability as a decreasing function of the atomic oxygen coverage in the chemisorbed phase. The model also takes into account the migration of oxygen atoms from oxide domains to domains with chemisorbed oxygen atoms. According to the model, the reaction rate initially increases with the CO exposure because the rate of CO chemisorption is enhanced as the coverage of chemisorbed oxygen atoms decreases during reaction. Longer rate delays are predicted for the partially oxidized surface because oxygen migration from the oxide phase maintains high oxygen coverages in the coexisting chemisorbed oxygen phase that hinder CO chemisorption. It is shown that the time evolution of the CO oxidation rate is determined by the relative rates of CO chemisorption and oxygen migration, R(ad) and R(m), respectively, with an increase in the relative rate of oxygen migration acting to inhibit the reaction. We find that the time lag in the reaction rate increases nearly exponentially with the initial oxygen coverage [O](i) (tot) when [O](i) (tot) exceeds a critical value, which is defined as the coverage above which R(ad)R(m) is less than unity at fixed CO incident flux and surface temperature. These results demonstrate that the kinetics for CO oxidation on oxidized Pt(111) is governed by the sensitivity of CO binding and chemisorption on the atomic oxygen coverage and the distribution of surface oxygen phases.

Combined Ambient Pressure Xps, High Pressure Stm, And Dft Study Of The In Situ Oxidation Of Pt(110) And The Reaction Of Gas Phase Co With Two Distinct Surface Oxygen Species

In Situ Oxidation Study of Pt(110) and Its Interaction with CO.

Oxidation Of Pt(110)

High-Pressure Co Oxidation On Pt(111) Monitored With Infrared-Visible Sum Frequency Generation (Sfg)

Structure And Activity Of Oxidized Pt(110) And Alpha-Pto2

In situ ambient pressure XPS study of Pt/Cu(111) single-atom alloy in catalytically relevant reaction conditions

Oxidation of Platinum Surfaces and Reaction with Carbon Monoxide

Structure and activity of oxidized Pt ( 110 ) and a-PtO 2

Dissociative Adsorption of O2 on Clean and CO-Precovered Pt Surfaces

Growth and Decomposition of Pt Surface Oxides

Sfg and Stm Studies of the Pt(111) Crystal Face at Atmospheric Co and Oxygen Pressures: Preparation of Platinum Nanocluster Arrays

Tuning SMSI Kinetics on Pt-loaded TiO$_2$(110) by Choosing the Pressure: A Combined UHV / Near-Ambient Pressure XPS Study

CO oxidation on Pd(100) at technologically relevant pressure conditions: A first-principles kinetic Monte Carlo study

Revealing Surface Elemental Composition and Dynamic Processes Involved in Facet-Dependent Oxidation of Pt3Co Nanoparticles Via in Situ Transmission Electron Microscopy

Kinetics of the CO Oxidation Reaction on Pt(111) Studied by in Situ High-Resolution X-Ray Photoelectron Spectroscopy.

In situ X-ray photoelectron spectroscopy of model catalysts: At the edge of the gap

One-DimensionalPtO2at Pt Steps: Formation and Reaction with CO

Kinetics of CO oxidation on high-concentration phases of atomic oxygen on Pt(111)

Catalyst Architecture for Stable Single Atom Dispersion Enables Site-Specific Spectroscopic and Reactivity Measurements of CO Adsorbed to Pt Atoms, Oxidized Pt Clusters, and Metallic Pt Clusters on TiO2.

Adsorption and Reaction of CO and O2 on the Ag/Pt(110) Surface Studied by Photoemission Electron Microscopy

A theoretical study of CO oxidation and O2 activation for transition metal overlayers on SrTiO3 perovskite