Abstract:X‐ray standing waves on a thermally stable periodic multilayer have been used to evidence the partial coverage of Co nanoparticles by a titanium oxide support in a model catalyst, following high‐temperature reduction. The developed approach has potential for fundamental studies in thermally activated surface processes in catalysis, membranes and metallurgy.The strong metal–support interaction (SMSI) is a phenomenon observed in supported metal catalyst systems in which reducible metal oxide supports can form overlayers over the surface of active metal nanoparticles (NPs) under a hydrogen (H2) environment at elevated temperatures. SMSI has been shown to affect catalyst performance in many reactions by changing the type and number of active sites on the catalyst surface. Laboratory methods for the analysis of SMSI at the nanoparticle‐ensemble level are lacking and mostly based on indirect evidence, such as gas chemisorption. Here, we demonstrate the possibility to detect and characterize SMSIs in Co/TiOx model catalysts using the laboratory X‐ray standing wave (XSW) technique for a large ensemble of NPs at the bulk scale. We designed a thermally stable MoNx/SiNx periodic multilayer to retain XSW generation after reduction with H2 gas at 600°C. The model catalyst system was synthesized here by deposition of a thin TiOx layer on top of the periodic multilayer, followed by Co NP deposition via spare ablation. A partial encapsulation of Co NPs by TiOx was identified by analyzing the change in Ti atomic distribution. This novel methodological approach can be extended to observe surface restructuring of model catalysts in situ at high temperature (up to 1000°C) and pressure (≤3 mbar), and can also be relevant for fundamental studies in the thermal stability of membranes, as well as metallurgy.

Tuning SMSI Kinetics on Pt-loaded TiO$_2$(110) by Choosing the Pressure: A Combined UHV / Near-Ambient Pressure XPS Study

In Situ Oxidation Study of Pt(110) and Its Interaction with CO.

Combined Ambient Pressure Xps, High Pressure Stm, And Dft Study Of The In Situ Oxidation Of Pt(110) And The Reaction Of Gas Phase Co With Two Distinct Surface Oxygen Species

Stability of platinum nanoparticles supported on SiO2/Si(111): a high-pressure X-ray photoelectron spectroscopy study

Encapsulation of Platinum by Titania under an Oxidative Atmosphere: Contrary to Classical Strong Metal–Support Interactions

Catalyst Architecture for Stable Single Atom Dispersion Enables Site-Specific Spectroscopic and Reactivity Measurements of CO Adsorbed to Pt Atoms, Oxidized Pt Clusters, and Metallic Pt Clusters on TiO2.

Restructuring of titanium oxide overlayers over nickel nanoparticles during catalysis

In situ ambient pressure XPS study of Pt/Cu(111) single-atom alloy in catalytically relevant reaction conditions

Strong Metal-Support Interactions Between Pt Single Atoms and TiO2.

Bridging the Pressure Gap in CO Oxidation

Reversible transformation between terrace and step sites of Pt nanoparticles on titanium under CO and O 2 environments

X‐ray standing wave characterization of the strong metal–support interaction in Co/TiOx model catalysts

Modulating the surface defects of titanium oxides and consequent reactivity of Pt catalysts

Reversible Transformation Between Terrace and Step Sites of Pt Nanoparticles on Titanium under CO and O2 Environments

In situ X-ray photoelectron spectroscopy of model catalysts: At the edge of the gap

Significance of Epitaxial Growth of PtO2 on Rutile TiO2 for Pt/TiO2 Catalysts.

Imaging of low temperature induced SMSI on Pd/TiO2 catalysts

Photoinduced Strong Metal–Support Interaction for Enhanced Catalysis

Direct Evidence of Dynamic Metal Support Interactions in Co/TiO2 Catalysts by Near-Ambient Pressure X-ray Photoelectron Spectroscopy

Strong Metal‐Support Interaction between Pt and TiO2 over High‐temperature CO2 Hydrogenation

Oxidation of Platinum Surfaces and Reaction with Carbon Monoxide