Abstract:First-principles kinetic Monte Carlo (1p-kMC) simulations for CO oxidation on two RuO2 facets, RuO2(110) and RuO2(111), were coupled to the computational fluid to dynamics (CFD) simulations package MFIX, and reactor-scale simulations were then performed. 1p-kMC coupled with CFD has recently been shown as a feasible method for translating molecular scale mechanistic knowledge to the reactor scale, enabling comparisons to in situ and online experimental measurements. Only a few studies with such coupling have been published. This work incorporates multiple catalytic surface facets into the scale-coupled simulation, and three possibilities were investigated: the two possibilities of each facet individually being the dominant phase in the reactor, and also the possibility that both facets were present on the catalyst particles in the ratio predicted by an ab initio thermodynamics-based Wulff construction. When lateral interactions between adsorbates were included in the 1p-kMC simulations, the two surfaces, RuO2(110) and RuO2(111), were found to be of similar order-of-magnitude in activity for the pressure range of 1 x 10(-4) bar to 1 bar, with the RuO2(110) surface-termination showing more simulated activity than the RuO2(111) surface-termination. Coupling between the 1p-kMC and CFD was achieved with a lookup table generated by the error-based modified Shepard interpolation scheme. Isothermal reactor scale simulations were performed and compared to two separate experimental studies, conducted with reactant partial pressures of <= 0.1 bar. Simulations without an isothermality restriction were also conducted and showed that the simulated temperature gradient across the catalytic reactor bed is <0.5 K, which validated the use of the isothermality restriction for investigating the reactor-scale phenomenological temperature dependences. The approach with the Wulff construction based reactor simulations reproduced a trend similar to one experimental data set relatively well, with the (110) surface being more active at higher temperaures; in contrast, for the other experimental data set, our reactor simulations achieve surprisingly and perhaps fortuitously good agreement with the activity and phenomenological pressure dependence when it is assumed that the (111) facet is the only active facet present. The active phase of catalytic CO oxidation over RuO2 remains unsettled, but the present study presents proof of principle (and progress) toward more accurate multiscale modeling from electrons to reactors and new simulation results.

CO oxidation on Pd(100) at technologically relevant pressure conditions: A first-principles kinetic Monte Carlo study

CO oxidation at Pd(100): A first-principles constrained thermodynamics study

CO oxidation on Pd(100) vs. PdO(sqrt5xsqrt5)R27^o: First-Principles Kinetic Phase Diagrams and Bistability Conditions

Synergistic Inhibition of Oxide Formation in Oxidation Catalysis: A First-Principles Kinetic Monte Carlo Study of NO + CO Oxidation at Pd(100)

In Situ Oxidation Study of Pt(110) and Its Interaction with CO.

First-principles kinetic Monte Carlo simulations for heterogeneous catalysis, applied to the CO oxidation at RuO2(110)

Bistability for CO Oxidation: an Understanding from Extended Phenomenological Kinetics Simulations

CO oxidation trends on Pt-group metals from ultrahigh vacuum to near atmospheric pressures: A combined in situ PM-IRAS and reaction kinetics study

Insight into the Active Phase of CO Oxidation on Ni/Pt and NiO1−x/Pt Model Catalysts from a First Principles Investigation

Co Adsorption on Pt (111) and Pd (111) Surfaces: A First-Principles Based Lattice Gas Monte-Carlo Study

Electrons to Reactors Multiscale Modeling: Catalytic CO Oxidation over RuO2

Structure Sensitivity in Oxide Catalysis: First-Principles Kinetic Monte Carlo Simulations for CO Oxidation at RuO$_2$(111)

In situ X-ray photoelectron spectroscopy of model catalysts: At the edge of the gap

Oxidation of Platinum Surfaces and Reaction with Carbon Monoxide

Mechanism for the High Reactivity of CO Oxidation on a Ruthenium–oxide

Kinetics and Active Surfaces for CO Oxidation on Pt-Group Metals under Oxygen Rich Conditions

Highly active surfaces for CO oxidation on Rh, Pd, and Pt

CO Oxidation on Pt-Group Metals from Ultrahigh Vacuum to Near Atmospheric Pressures. 1. Rhodium

Composition and structure of the RuO2(110) surface in an O2 and CO environment: implications for the catalytic formation of CO2

CO oxidation by Pt2/Fe3O4: metastable dimer and support configurations facilitate lattice oxygen extraction

Oscillatory Oxidation of CO on Pt(100): Monte Carlo Simulations