Abstract:Temperature-programmed reaction spectroscopy (TPRS) and direct, isothermal reaction-rate measurements were employed to investigate the oxidation of CO on Pt(111) covered with high concentrations of atomic oxygen. The TPRS results show that oxygen atoms chemisorbed on Pt(111) at coverages just above 0.25 ML (monolayers) are reactive toward coadsorbed CO, producing CO(2) at about 295 K. The uptake of CO on Pt(111) is found to decrease with increasing oxygen coverage beyond 0.25 ML and becomes immeasurable at a surface temperature of 100 K when Pt(111) is partially covered with Pt oxide domains at oxygen coverages above 1.5 ML. The rate of CO oxidation measured as a function of CO beam exposure to the surface exhibits a nearly linear increase toward a maximum for initial oxygen coverages between 0.25 and 0.50 ML and constant surface temperatures between 300 and 500 K. At a fixed CO incident flux, the time required to reach the maximum reaction rate increases as the initial oxygen coverage is increased to 0.50 ML. A time lag prior to the reaction-rate maximum is also observed when Pt oxide domains are present on the surface, but the reaction rate increases more slowly with CO exposure and much longer time lags are observed, indicating that the oxide phase is less reactive toward CO than are chemisorbed oxygen atoms on Pt(111). On the partially oxidized surface, the CO exposure needed to reach the rate maximum increases significantly with increases in both the initial oxygen coverage and the surface temperature. A kinetic model is developed that reproduces the qualitative dependence of the CO oxidation rate on the atomic oxygen coverage and the surface temperature. The model assumes that CO chemisorption and reaction occur only on regions of the surface covered by chemisorbed oxygen atoms and describes the CO chemisorption probability as a decreasing function of the atomic oxygen coverage in the chemisorbed phase. The model also takes into account the migration of oxygen atoms from oxide domains to domains with chemisorbed oxygen atoms. According to the model, the reaction rate initially increases with the CO exposure because the rate of CO chemisorption is enhanced as the coverage of chemisorbed oxygen atoms decreases during reaction. Longer rate delays are predicted for the partially oxidized surface because oxygen migration from the oxide phase maintains high oxygen coverages in the coexisting chemisorbed oxygen phase that hinder CO chemisorption. It is shown that the time evolution of the CO oxidation rate is determined by the relative rates of CO chemisorption and oxygen migration, R(ad) and R(m), respectively, with an increase in the relative rate of oxygen migration acting to inhibit the reaction. We find that the time lag in the reaction rate increases nearly exponentially with the initial oxygen coverage [O](i) (tot) when [O](i) (tot) exceeds a critical value, which is defined as the coverage above which R(ad)R(m) is less than unity at fixed CO incident flux and surface temperature. These results demonstrate that the kinetics for CO oxidation on oxidized Pt(111) is governed by the sensitivity of CO binding and chemisorption on the atomic oxygen coverage and the distribution of surface oxygen phases.

Oscillatory Oxidation of CO on Pt(100): Monte Carlo Simulations

Effect of Inert Species in Gas Phase on Oscillatory Dynamics of Oxidation System of CO on Pt(100).

Catalytic Oscillatory Oxidation of CO on Pt(110): On-off Control to Chaos

CO oxidation on Pd(100) vs. PdO(sqrt5xsqrt5)R27^o: First-Principles Kinetic Phase Diagrams and Bistability Conditions

High-Pressure Co Oxidation On Pt(111) Monitored With Infrared-Visible Sum Frequency Generation (Sfg)

CO oxidation on Pd(100) at technologically relevant pressure conditions: A first-principles kinetic Monte Carlo study

Coherent Resonance for Rate Oscillations During CO Oxidation on Pt(110) Surfaces: Interplay Between Internal and External Noise

Kinetics of CO oxidation on high-concentration phases of atomic oxygen on Pt(111)

Co Adsorption on Pt (111) and Pd (111) Surfaces: A First-Principles Based Lattice Gas Monte-Carlo Study

In Situ Oxidation Study of Pt(110) and Its Interaction with CO.

Theoretical Study on the Effects of Internal Noise for Rate Oscillations During CO Oxidation on Platinum(110) Surfaces

Kinetics of the CO Oxidation Reaction on Pt(111) Studied by in Situ High-Resolution X-Ray Photoelectron Spectroscopy.

Oxidation of Platinum Surfaces and Reaction with Carbon Monoxide

Effects of external global noise on the catalytic CO oxidation on Pt(110)

Stochastic Resonance in Surface Catalytic Oxidation of Carbon Monoxide Induced by Colored Noise

Dissociative Adsorption of O2 on Clean and CO-Precovered Pt Surfaces

CO oxidation at Pd(100): A first-principles constrained thermodynamics study

The Defect-Mediated Mechanism of the High-Temperature Oscillatory NO + CO Reaction on Pt{100} As Revealed by Real-Time in-situ Vibrational Spectroscopy

Structure Sensitivity in Oxide Catalysis: First-Principles Kinetic Monte Carlo Simulations for CO Oxidation at RuO$_2$(111)

Decay of Metastable Nonequilibrium Phases, Enhanced Reaction Rate, and Dynamic Phase Transition in a Model of CO Oxidation with CO Desorption

Adsorption of CO and desorption of CO2 interacting with Pt (111) surface: a combined density functional theory and Kinetic Monte Carlo simulation