Abstract:Temperature-programmed reaction spectroscopy (TPRS) and direct, isothermal reaction-rate measurements were employed to investigate the oxidation of CO on Pt(111) covered with high concentrations of atomic oxygen. The TPRS results show that oxygen atoms chemisorbed on Pt(111) at coverages just above 0.25 ML (monolayers) are reactive toward coadsorbed CO, producing CO(2) at about 295 K. The uptake of CO on Pt(111) is found to decrease with increasing oxygen coverage beyond 0.25 ML and becomes immeasurable at a surface temperature of 100 K when Pt(111) is partially covered with Pt oxide domains at oxygen coverages above 1.5 ML. The rate of CO oxidation measured as a function of CO beam exposure to the surface exhibits a nearly linear increase toward a maximum for initial oxygen coverages between 0.25 and 0.50 ML and constant surface temperatures between 300 and 500 K. At a fixed CO incident flux, the time required to reach the maximum reaction rate increases as the initial oxygen coverage is increased to 0.50 ML. A time lag prior to the reaction-rate maximum is also observed when Pt oxide domains are present on the surface, but the reaction rate increases more slowly with CO exposure and much longer time lags are observed, indicating that the oxide phase is less reactive toward CO than are chemisorbed oxygen atoms on Pt(111). On the partially oxidized surface, the CO exposure needed to reach the rate maximum increases significantly with increases in both the initial oxygen coverage and the surface temperature. A kinetic model is developed that reproduces the qualitative dependence of the CO oxidation rate on the atomic oxygen coverage and the surface temperature. The model assumes that CO chemisorption and reaction occur only on regions of the surface covered by chemisorbed oxygen atoms and describes the CO chemisorption probability as a decreasing function of the atomic oxygen coverage in the chemisorbed phase. The model also takes into account the migration of oxygen atoms from oxide domains to domains with chemisorbed oxygen atoms. According to the model, the reaction rate initially increases with the CO exposure because the rate of CO chemisorption is enhanced as the coverage of chemisorbed oxygen atoms decreases during reaction. Longer rate delays are predicted for the partially oxidized surface because oxygen migration from the oxide phase maintains high oxygen coverages in the coexisting chemisorbed oxygen phase that hinder CO chemisorption. It is shown that the time evolution of the CO oxidation rate is determined by the relative rates of CO chemisorption and oxygen migration, R(ad) and R(m), respectively, with an increase in the relative rate of oxygen migration acting to inhibit the reaction. We find that the time lag in the reaction rate increases nearly exponentially with the initial oxygen coverage [O](i) (tot) when [O](i) (tot) exceeds a critical value, which is defined as the coverage above which R(ad)R(m) is less than unity at fixed CO incident flux and surface temperature. These results demonstrate that the kinetics for CO oxidation on oxidized Pt(111) is governed by the sensitivity of CO binding and chemisorption on the atomic oxygen coverage and the distribution of surface oxygen phases.

Effect of Inert Species in Gas Phase on Oscillatory Dynamics of Oxidation System of CO on Pt(100).

Oscillatory Oxidation of CO on Pt(100): Monte Carlo Simulations

Effect of Surface Impurities on Oscillation in No+Co/Pt(100) Reaction System

Effects of inert species in the gas phase in a model for the catalytic oxidation of CO

Effects of external global noise on the catalytic CO oxidation on Pt(110)

Catalytic Oscillatory Oxidation of CO on Pt(110): On-off Control to Chaos

Bistability for CO Oxidation: an Understanding from Extended Phenomenological Kinetics Simulations

Optimal Particle Size for Reaction Rate Oscillation in CO Oxidation on Nanometer-Sized Palladium Particles

Effect of the Coadsorption of CO and O2 on the Phase Diagram of the Ziff-Gulari-Barshad Model

Theoretical Study on the Effects of Internal Noise for Rate Oscillations During CO Oxidation on Platinum(110) Surfaces

High-Pressure Co Oxidation On Pt(111) Monitored With Infrared-Visible Sum Frequency Generation (Sfg)

Coherent Resonance for Rate Oscillations During CO Oxidation on Pt(110) Surfaces: Interplay Between Internal and External Noise

CO oxidation on Pd(100) vs. PdO(sqrt5xsqrt5)R27^o: First-Principles Kinetic Phase Diagrams and Bistability Conditions

Co Adsorption on Pt (111) and Pd (111) Surfaces: A First-Principles Based Lattice Gas Monte-Carlo Study

Internal Noise Stochastic Resonance in CO Oxidation on Nm-Sized Palladium Particles

Decay of Metastable Nonequilibrium Phases, Enhanced Reaction Rate, and Dynamic Phase Transition in a Model of CO Oxidation with CO Desorption

Self-Inhibition Phenomena in Cu3Pt Oxidation by CO2

Kinetics of CO oxidation on high-concentration phases of atomic oxygen on Pt(111)

In Situ Oxidation Study of Pt(110) and Its Interaction with CO.

Kinetic Study and the Effect of Particle Size on Low Temperature CO Oxidation over Pt/TiO2 Catalysts

Complete CO Oxidation by O2 and H2O over Pt–CeO2−δ/MgO Following Langmuir–Hinshelwood and Mars–van Krevelen Mechanisms, Respectively