Abstract:Abstract This paper presents 3D Fabry–Pérot (FP) cavities fabricated directly onto cleaved ends of low-loss optical fibers by a two-photon polymerization (2PP) process. This fabrication technique is quick, simple, and inexpensive compared to planar microfabrication processes, which enables rapid prototyping and the ability to adapt to new requirements. These devices also utilize true 3D design freedom, facilitating the realization of microscale optical elements with challenging geometries. Three different device types were fabricated and evaluated: an unreleased single-cavity device, a released dual-cavity device, and a released hemispherical mirror dual-cavity device. Each iteration improved the quality of the FP cavity’s reflection spectrum. The unreleased device demonstrated an extinction ratio around 1.90, the released device achieved 61, and the hemispherical device achieved 253, providing a strong signal to observe changes in the free spectral range of the device’s reflection response. The reflectance of the photopolymer was also estimated to be between 0.2 and 0.3 over the spectrum of interest. The dual-cavity devices include both an open cavity, which can interact with an interstitial medium, and a second solid cavity, which provides a static reference reflection. The hemispherical dual-cavity device further improves the quality of the reflection signal with a more consistent resonance, and reduced sensitivity to misalignment. These advanced features, which are very challenging to realize with traditional planar microfabrication techniques, are fabricated in a single patterning step. The usability of these FP cavities as thermal radiation sensors with excellent linear response and sensitivity over a broad range of temperature is reported. The 3D structuring capability the 2PP process has enabled the creation of a suspended FP heat sensor that exhibited linear response over the temperature range of 20 oC –120 oC; temperature sensitivity of ∼50 pm oC −1 at around 1550 nm wavelength; and sensitivity improvement of better than 9x of the solidly-mounted sensors.

Enhanced Spatial Light Coupling Efficiency of Polymer Optical Fiber via Micro-lens Self-heating Melting Technique

Artificial Compound Eye-Tipped Optical Fiber for Wide Field Illumination.

Study on thermal splicing of ZBLAN fiber to silica fiber

Filament Fusion of Hollow-Core Photonic Crystal Fiber and Single Mode Fiber: Numerical Simulation and Experimental Analysis

A Simple Approach to Fiber-Based Tunable Microcavity with High Coupling Efficiency

Photopolymer Microtips for Efficient Light Coupling Between Single-Mode Fibers and Small-Core Photonic Crystal Fibers

High-efficiency Grating Coupler Based on Fast Directional Optimization and Robust Layout Strategy in 130 Nm CMOS Process.

Novel fiber taper for efficient optical interconnection

Three-dimensional Fabry–Pérot cavities sculpted on fiber tips using a multiphoton polymerization process

Underwater Wireless-To-Plastic Optical Fiber Communication Systems With A Passive Front End

Fused taper technique for fiber coupling applications

Fusion Splicing Soft Glass Microfibers for Photonic Devices

Direct coupling of high-power LD to the multi-mode optical fiber

Extremely High-Efficiency Coupling Method for Hollow-Core Photonic Crystal Fiber

Brillouin scattering signal in polymer optical fiber enhanced by exploiting pulsed pump with multimode-fiber-assisted coupling technique.

A Design of Optical Fiber Microcoupler with Laser-Fused Biconical Tapers

Double-end low-loss coupling of anti-resonant hollow-core fibers with solid-core single-mode fibers by tapering technique

Free-form micro-optics enabling ultra-broadband low-loss fiber-to-chip coupling

Low-Loss Coupling from Coated Plano Convex Lens to Single Mode Solid Core Fibers Laser by Lensing Scheme

Polymer Micro or Nanofibers for Optical Device Applications

An Organic Microcavity Laser Amplifier Integrated on the End Facet of an Optical Fiber