Abstract:Pool boiling is a widely encountered heat transfer phenomenon and the enhancement of boiling heat transfer performance is of vital importance for real applications. Adding surfactant into distilled water is regarded to be a promising and effective approach for heat transfer improvement. The present study selected four kinds of quaternary ammonium cationic surfactants with an increased molecular weight, namely, decyltrimethylammonium bromide (DeTAB), dodecyltrimethylammonium bromide (DoTAB), myristylmethylammonium bromide (MTAB) and cetyltrimethylammonium bromide (CTAB), to investigate the pool boiling performance of their aqueous solutions on a copper heater with and without electric field under different concentrations. Their dynamic surface tensions and viscosities were also measured. The bubble dynamics during pool boiling and apparent contact angle on copper surface before and after boiling test were evaluated. Experimental results reveal that the aqueous surfactant solution can significantly enhance the heat transfer coefficient (HTC) compared with distilled water. The HTC exhibits an increment with concentration until critical micelle concentration (CMC) and then levels off. The maximum relative HTC enhancement can reach up to 209.3%, which is ascribed to the increased nucleate site and bubble departure frequency. In addition to the reduction in surface tension, a repulsion force caused by electrostatic interaction is also responsible for the changes in nucleate site and bubble departure frequency. However, the critical heat flux (CHF) shows a continuous decrement with surfactant concentration. In a low concentration surfactant solution, the CHF is even slightly higher than that of water, which is caused by an improvement in surface wettability after boiling test. The CHF in moderate and high surfactant concentration will be lower. The surfactant with a smaller CMC tends to have a higher HTC and a lower CHF under a low concentration. However, for a relatively high concentration comparative to CMC, the four kinds of quaternary ammonium cationic surfactant solutions tend to have pretty similar boiling curves. The electric field is found to have a negligible influence on the pool boiling performance in aqueous surfactant solutions. Results in present study can provide valuable guidance for surfactant selection during the design of highly effective heat exchangers.

Impacts of Salt Concentration on Nucleate Pool Boiling of NaCl Solution

Pool Boiling Heat Transfer During Quenching on a Superhydrophilic Surface in Dilute Aqueous Saline Solutions: Effects of the Solution Concentration and Type of Salts

Experimental Study of Heat Transfer and Bubble Behaviors of NaCl Solutions During Nucleate Flow Boiling

Experimental and Numerical Study of Nucleate Pool Boiling Heat Transfer and Bubble Dynamics in Saline Solution

HEAT TRANSFER CHARACTERISTICS AND BUBBLE BEHAVIORS DURING NUCLEATE FLOW BOILING FOR SODIUM CHLORIDE SOLUTION

Subcooled Pool Film Boiling Heat Transfer from Spheres with Superhydrophobic Surfaces: an Experimental Study

Wall Heat Flux Partitioning During Subcooled Flow Boiling of NaCl Solutions and Pure Water

Regulated Transient Pool Boiling of Water During Quenching on Nanostructured Surfaces with Modified Wettability from Superhydrophilic to Superhydrophobic

Effects of chloride ion concentration on porous surfaces and boiling heat transfer performance of porous surfaces

Experimental study on subcooled pool boiling heat transfer of sodium dodecyl sulfate surfactant solution

Bubble Growth in NaCl Solution: Influence of Superheat Temperature and Solution Concentration

Visualization and quantitative study on film boiling heat transfer of a salt droplet on the hydrophobic substrate

Comparison of pool boiling heat transfer performance between aqueous cationic and anionic surfactant solutions with similar ionic group

Experimental study on the influence of heating surface inclination angle on heat transfer and CHF performance for pool boiling

Lattice Boltzmann Simulations of Macro/Microscale Effects on Saturated Pool Boiling Curves for Heated Horizontal Surfaces

Effect of nanoparticle concentration and surfactants on nanofluid pool boiling

Effects of surface wettability on nucleate pool boiling heat transfer for surfactant solutions

Experimental study on impact patterns and dynamics characteristics of NaCl water droplet with different concentrations on heated surface

Pool boiling heat transfer enhancement of aqueous solution with quaternary ammonium cationic surfactants on copper surface

Lattice Boltzmann simulations for surface wettability effects in saturated pool boiling heat transfer

Synergistic Effects of Hydrophilic-Hydrophobic Porous Structures for Enhancing Nucleate Pool Boiling Heat Transfer