Abstract:Pool boiling is a widely encountered heat transfer phenomenon and the enhancement of boiling heat transfer performance is of vital importance for real applications. Adding surfactant into distilled water is regarded to be a promising and effective approach for heat transfer improvement. The present study selected four kinds of quaternary ammonium cationic surfactants with an increased molecular weight, namely, decyltrimethylammonium bromide (DeTAB), dodecyltrimethylammonium bromide (DoTAB), myristylmethylammonium bromide (MTAB) and cetyltrimethylammonium bromide (CTAB), to investigate the pool boiling performance of their aqueous solutions on a copper heater with and without electric field under different concentrations. Their dynamic surface tensions and viscosities were also measured. The bubble dynamics during pool boiling and apparent contact angle on copper surface before and after boiling test were evaluated. Experimental results reveal that the aqueous surfactant solution can significantly enhance the heat transfer coefficient (HTC) compared with distilled water. The HTC exhibits an increment with concentration until critical micelle concentration (CMC) and then levels off. The maximum relative HTC enhancement can reach up to 209.3%, which is ascribed to the increased nucleate site and bubble departure frequency. In addition to the reduction in surface tension, a repulsion force caused by electrostatic interaction is also responsible for the changes in nucleate site and bubble departure frequency. However, the critical heat flux (CHF) shows a continuous decrement with surfactant concentration. In a low concentration surfactant solution, the CHF is even slightly higher than that of water, which is caused by an improvement in surface wettability after boiling test. The CHF in moderate and high surfactant concentration will be lower. The surfactant with a smaller CMC tends to have a higher HTC and a lower CHF under a low concentration. However, for a relatively high concentration comparative to CMC, the four kinds of quaternary ammonium cationic surfactant solutions tend to have pretty similar boiling curves. The electric field is found to have a negligible influence on the pool boiling performance in aqueous surfactant solutions. Results in present study can provide valuable guidance for surfactant selection during the design of highly effective heat exchangers.

Experimental study on subcooled pool boiling heat transfer of sodium dodecyl sulfate surfactant solution

Subcooled Pool Film Boiling Heat Transfer from Spheres with Superhydrophobic Surfaces: an Experimental Study

Experimental Investigation of Spray Cooling Performance in Non‐boiling Zone on Rough Superhydrophilic/hydrophobic Surfaces

Pool Boiling Heat Transfer During Quenching on a Superhydrophilic Surface in Dilute Aqueous Saline Solutions: Effects of the Solution Concentration and Type of Salts

Effects of Surface Modification on the Pool Boiling Heat Transfer of MWNTs/water Nanofluids

Comparison of pool boiling heat transfer performance between aqueous cationic and anionic surfactant solutions with similar ionic group

Mechanisms for Enhanced Transition Boiling During Quenching on a Superhydrophilic Surface As Revealed by in Situ Characterization on the Solid-Liquid Contact Using Electrochemical Impedance Technique

Regulated Transient Pool Boiling of Water During Quenching on Nanostructured Surfaces with Modified Wettability from Superhydrophilic to Superhydrophobic

Experimental Investigation of the Influence of Surfactant on the Heat Transfer Performance of Pulsating Heat Pipe

Effects of surface wettability on nucleate pool boiling heat transfer for surfactant solutions

Bubble behaviors during subcooled pool boiling in water and nonionic surfactant aqueous solution

Pool boiling heat transfer enhancement of aqueous solution with quaternary ammonium cationic surfactants on copper surface

Experimental Study of Heat Transfer and Bubble Behaviors of NaCl Solutions During Nucleate Flow Boiling

Experimental and Analytical Study on the Influence of Saturation Pressure and Surface Roughness on Pool Boiling CHF of HFE-7100

Multiphase SPH Modeling of Water Boiling on Hydrophilic and Hydrophobic Surfaces

CHF and heat transfer enhancement by SiO 2 nanofluids on a inclined downward facing heating surface

Effect of nanoparticle concentration and surfactants on nanofluid pool boiling

Numerical Study on Bubble Departing Behavior from Heated Surface in Subcooled Pool Boiling

Visualization and quantitative study on film boiling heat transfer of a salt droplet on the hydrophobic substrate

Changes in boiling controlled by molar concentration-dependent diffusion of surfactants

Experimental and Numerical Study of Nucleate Pool Boiling Heat Transfer and Bubble Dynamics in Saline Solution