Abstract:Reactivity controlled compression ignition (RCCI) combustion is a advanced low temperature combustion concept to reduce CO 2 and brake the trade-off between NOx and PM emissions for next generation compression ignition (CI) engines. However, it leads to the more complex multi-stage heat release in diesel/natural gas (NG) dual fuel engines and is criticized for extra-high methane and carbon monoxide emissions. Using the existing methods, it is difficult to effectively quantify the contribution of the accumulated heat release (AHR) at each stage to the whole combustion process and to create their relevance to the performance and emissions in the RCCI engines. In this paper, experiments were conducted on a ship diesel/NG dual-fuel engine at a load of 25 %. A new identification and quantitative analysis method of multi-stage heat release is proposed, and the coupling effects of the diesel split injection parameters on the multi-stage heat release and performance in the RCCI engine were revealed. The results show that the new method is not only available for analyzing the combustion of traditional CI engines but also is more effective for identifying the multi-stage combustion in RCCI engines. For the increased pre-injection ratio (PR), as the start of first injection (SOI-I) and the start of second injection (SOI-II) advance, the AHR in Stage-I (Q-Stage-I) decreases, and the increased Q-Stage-III lead to the improved indicated thermal efficiency (ITE > 49 %). Meanwhile, methane (CH 4 ), non-methane hydrocarbon (NMHC) and carbon monoxide (CO) emissions can be reduced by more than 50 %, while nitrogen oxides (NOx) emissions increase. The impact significance of SOI-II on Q-Stage-I and Q-Stage-III is higher, their values are + 65.88 % and −51.04 %, respectively, and the Q-Stage-II is mainly controlled by SOI-I. The impact significance of Q-Stage-III on ITE is the highest about + 69.43 %. Q-Stage-I shows a higher positive correlation with CH 4 , NMHC and CO emissions although the proportion of Q-Stage-I is far smaller than that of Q-Stage-II and Q-Stage-III. Therefore, the simultaneous reduction of incomplete combustion products and NOx emission can be achieved by reasonably adjusting split injection parameters.

Effect of direct water injection timing on cycle performance and emissions characteristics within a CI-ICRC engine

Numerical Investigation of the Effect of Injection Timing on the In-Cylinder Activity of a Gasoline Direct Injection Engine

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Effect of direct water injection on combustion and emissions characteristics of marine diesel engines

Numerical Study on Double Injection Techniques in a Gasoline and Biodiesel Fueled RCCI (reactivity Controlled Compression Ignition) Engine

Investigations on reactivity controlled compression ignition combustion with different injection strategies using alternative fuels produced from waste resources

Experimental Investigation of Homogeneous Charge Induced Ignition (hcii) with Low-Pressure Injection to Reduce Pm Emissions in A Heavy-Duty Engine

Experimental Study on the Diesel Injection Pressure of Homogeneous Charge Induced Ignition for Multi-cylinder Operation

Quantitative Analysis of Water Injection Mass and Timing Effects on Oxy-Fuel Combustion Characteristics in a GDI Engine Fuelled with E10

An Experimental Study on SICI Combustion in Gasoline Direct Injection Engine with Variable Valve Timing

Effect of split injection strategy of diesel fuel on multi-stage heat release and performance of a RCCI engine fueled with diesel and natural gas

Research on low temperature combustion of homogeneous charge induced ignition (HCII) in a light-duty diesel engine

Experimental investigation on the combustion and emissions in a pilot ignited direct injection natural gas engine using HCDI strategy

Effect of piston bowl geometry and compression ratio on in-cylinder combustion and engine performance in a gasoline direct-injection compression ignition engine under different injection conditions

A study on supercritical water injection as waste heat recovery system in internal combustion engines

Investigation of water spray evolution process of port water injection and its effect on engine performance

Effects of mixing and chemical parameters on homogeneous charge induced ignition combustion based on a light-duty diesel engine with ultra-Low NOx and soot emissions and high thermal efficiency

The Effect of Control Strategies on the Gasoline Compression Ignition (GCI) Engine: Injection Strategy, Exhaust Residual Gas Strategy, Biodiesel Addition Strategy, and Oxygen Content Strategy

Research on steady and transient performance of an HCCI engine with gasoline direct injection

Experimental research of direct water injection characteristics over wide range of injection temperature and ambient pressure

Advancing RCCI engine performance via optimal acetylene premix ratios and advanced diesel injection timing: An experimental investigation