Abstract:Surface texturing is an effective technology for enhancing lubrication and anti-wear properties through hydrodynamic effects and secondary lubrication. In this study, two types of variable-depth groove textures were designed to enhance the lubrication performance of friction pairs. Based on theoretical analysis, the coefficient of friction (COF), wear characteristics, and triboelectric open-circuit voltages produced by different textures were evaluated in a series of experiments. Using a friction testing setup, scanning electron microscopy, energy dispersive spectrometry, an electrometer (Keithley 6514), Raman spectroscopy, surface microtopography, and lubrication mechanisms were revealed. First, two types of variable-depth groove textures were designed based on computational fluid dynamics. Second, SiC samples with these textures were fabricated using laser surface texturing technology, and ball–disk rotary friction experiments were performed. During the friction tests, the shallow inner and deep outer (SDT) groove textures exhibited a lower COF at medium and low speeds under varying loads. Finally, the lubrication mechanism was attributed to the synergistic effect of four factors: the hydrodynamic effect of the lubricant, enhanced ability of debris expulsion, oxide tribofilms at the interface, and polarization electric field generated at the solid–liquid interfaces between the lubricant and friction pair. The results indicate that the minimum COF of the SDT texture can be reduced to 0.025. These insights offer valuable guidance for design methods and new lubrication mechanisms for enhancing the lubrication and anti-wear properties of friction pairs in mechanical systems.

Quantitative Analysis of Grinding Performance of Cubic Silicon Carbide Surface Texture Lubricated with Water Film

Understanding of the effect of wear particles removal from the surface on grinding silicon carbide by molecular dynamics simulations

Numerical simulation of single abrasive grain grinding of silicon carbide surface

Molecular dynamics study of the removal mechanism of SiC in a fixed abrasive polishing in water lubrication

Impact of multiple abrasive particles on surface properties of SiC: A molecular dynamics simulation study

Enhancing Ductile Removal of Cf/SiC Composites During Abrasive Belt Grinding Using Low-Hardness Rubber Contact Wheels

Theoretical and Experimental Analysis on Super Precision Grinding of Monocrystal Silicon

Mechanism analysis and process optimization of nanogrinding single-crystal SiC

Experimental Investigation on Materials Removal Mechanism During Grinding Silicon Carbide Ceramics with Single Diamond Grain

Wear-induced variation of surface roughness in grinding 2.5D C f /SiC composites

Experimental study on ultrasonic-assisted grinding of micro-structured surface on silicon carbide using small diameter grinding wheel

Impact of Material Microstructure and Diamond Grit Wear on Surface Finish in Micro-Grinding of RB-SiC/Si and WC/Co Carbides

EXPERIMENTAL AND THEORETICAL INVESTIGATIONS ON TOOL WEAR AND SURFACE QUALITY IN MICRO MILLING OF SiCp/AI COMPOSITES UNDER DRY AND MQL CONDITIONS

Molecular Dynamics Analyze on Effects of Abrasive Size and Cut Depth on the Monocrystal Silicon Grinding

The Influence of Grain Geometry and Wear Conditions on the Material Removal Mechanism in Silicon Carbide Grinding with Single Grain

Influence of Variable-Depth Groove Texture on the Friction and Wear Performance of GCr15–SiC Friction Pairs Under Water Lubrication

Machining Characteristics And Removal Mechanisms Of Reaction Bonded Silicon Carbide

Effect of picosecond laser texturing on the friction behavior of silicon carbide in hybrid ceramic bearings under dry and water lubrication

Atomic Simulations of Deformation Mechanism of 3C-SiC Polishing Process with a Rolling Abrasive

Experimental Analysis of Ductile Cutting Regime in Face Milling of Sintered Silicon Carbide

Material removal mechanism and grinding force modelling of ultrasonic vibration assisted grinding for SiC ceramics