Abstract:The transition mechanism is of significance to the corrosion behavior of zirconium alloys. Two important phenomena may be the causes of transition, which are the undulated wavy interface and the existence of tetragonal zirconia at the metal/oxide interface. There is little detailed study on the correlation between these two features. Micro-scale Raman imaging of intensity and Raman shifts was conducted in this study to further evaluate the connection. It was studied based on the oxide films formed on Zr-0.5Sn-0.15Nb-0.5Fe-0.2 V and N36 claddings corroded in 500 degrees C/10.3 MPa steam. The stress in interfacial tetragonal zirconia has relationship with the amplitude to wavelength ratio of the undulated part and it is always found to be larger at the convex parts of interface. These parts are prone to crack formation. At one convex position that the oxide cracked, t-ZrO2 is found to be preserved beneath and above the crack. Stress is also preserved, but partially released. When interfacial t-ZrO2 exists, the stress in the surrounding monoclinic phase is observed to be small. This provides us a more detailed figure of the stress distribution in oxide film. Tetragonal phase is mainly distributed near the metal/oxide interface. More intense tetragonal signals are frequently found at the convex positions of interface. This might result from large tetragonal grains or aggregation of small t-ZrO2 grains. These grains are stabilized at convex parts because of the large compressive stress and might be unstable once the grain size exceeds a critical value or once cracks are formed at such positions. An illustration of the connection between t-ZrO2 and undulated interface is then proposed. Possible reasons that facilitate the formation of lateral cracks and possible reasons for the existence of t-ZrO2 at the convex positions are discussed. (C) 2019 Elsevier B.V. All rights reserved.

Unraveling Different Influences of the Fraction of the Tetragonal Phase in Oxide Films on the Corrosion Resistance of Zr Alloys from the Phase Transition Mechanism

Unraveling different influences of the fraction of tetragonal phase in oxide film on corrosion resistance of Zr alloys from phase transition mechanism

Effect of Nb and Cu on α/β Phase Transition Temperature and Corrosion Behavior of New Type Zirconium Alloys

An origin of corrosion resistance changes of Zr alloys: effects of Sn and Nb on grain boundary strength of surface oxide

The Origin of Corrosion Resistance Change Induced by Sn and Nb Alloying in Zr Alloys

The Correlation Between Tetragonal Phase and the Undulated Metal/oxide Interface in the Oxide Films of Zirconium Alloys

Phase-field Simulation of High-Temperature Corrosion of Binary Zr-2.5Sn Alloy

Study on Influence of Tetragonal ZrO2 in Oxide Film on Corrosion Resistance of Zr-Sn-Nb Alloy

Research on the Existence and Stability of Interfacial Tetragonal Zirconia Formed on Zirconium Alloys

Theoretical Investigation of Cu Influence on the Stability Characteristics of T-phase in Crossover Alloys

The formation of atomic and sub-nano scale pores under tensile strain in oxide films on Zr alloys: A first-principles study

Effect of Microstructure on Corrosion Behavior of A Zr-Sn-Nb-Fe-Cu-O Alloy

Investigation on corrosion behavior of Zr-bearing TA10-based titanium alloys

Effect of Zr addition on the microstructure, phase transformation and mechanical property of Ni 50 Mn 25 Ga 17 Cu 8 alloy

Effect of oxygen content in 400 °C super-heated steam on the corrosion resistance of Zr-xSn-0.35Fe-0.15Cr-0.15 Nb alloys

Anisotropic Kinetics of Solid Phase Transition from First Principles: Alpha-Omega Phase Transformation of Zr.

From Microstructural Changes to Electrochemical Behavior: Decoding the Corrosion Mechanism in Zr-Sn-Nb-Fe-Cr-Mo-O-V Alloys

Investigation of Precipitation Phases in As-Cast Wedge Ingot of Bulk Amorphous Zr56.6cu17.3ni12.5al9.6ti4 Alloy

Enhancing the Stability of the Ω Phase of Zirconium Alloys Via Local Interlayer Twists

Thickness Dependence of the Crystallization and Phase Transition in ZrO 2 Thin Films

Corrosion behaviors of Zr-Sn-Nb alloys: Influence of different concentration dissolved oxygen environment and trace V element on the anti-corrosion properties