Abstract:Synthesizing of alumino-borosilicate glasses in the SiO 2 -B 2 O 3 -Al 2 O 3 system using the sol–gel method was considered. Transparent and dense glasses were obtained by various heat treatment programs applied on the dried gels. The process of converting the gel to glass involves complex transformations including both structural and chemical changes. Consequently, investigating the sintering behavior of these synthesized powder holds significant academic merit. In order to achieve this objective, the density of monolithic glass was assessed subsequent to sintering at various temperatures. Besides, the sintering activation energy of glasses in both isothermal and non-isothermal circumstances was estimated. The relative density values for various sintered glass compositions were between 96.5- 99.6%. The sintering activation energy under isothermal condition for glasses exhibited an increase with increasing of aluminum oxide amounts from 237 up to 314 kJ/mol. Furthermore, the results showed that crystallization of the sample can increase its sintering activation energy up to 414 kJ/mol. Under non-isothermal condition and for different heating rate for the samples, the sintering activation energy values for glass which had the lowest content of Al 2 O 3 was the same. However, in the composition with the highest content of ZnO, its linear shrinkage increment indicated a significant decrease in its sintering activation energy despite the crystallization of the mullite phase within the glass.

Investigation of Sintering Behavior of Sol Gel Derived SiO2-Al2O3-B2O3 Glasses

Sintering Behavior, Microstructure and Mechanical Properties of Various Fluorine-Containing Y-SiAlON Glass-Ceramics

Preparation of monolithic transparent mullite-based glass-ceramics by the sol–gel method

Research on the Formation Process and Properties of Alumino-Borosilicate Glasses

Effects of Alumina Sols on the Sintering of Α-Alumina Ceramics

Microstructure and dielectric properties of glass/Al 2 O 3 composites with various low softening point borosilicate glasses

Effect of SiO2/Al2O3 ratio on sintering behavior, crystallization behavior and properties of diopside-anorthite glass-ceramics

OBTAINING OF ALKALINE-FREE ALUMINOSILICATE GLASS CERAMICS BY SOL-GEL METHOD AND INVESTIGANING OF ITS PROPERTIES

MgO-Al<sub>2</sub>O<sub>3</sub>-SiO<sub>2</sub> Glass-Ceramic Prepared by Sol-Gel Method

Effect of Alumina on Densification of Binary Borosilicate Glass Composite

Crystallization Behavior and Performance of MgO-Al2O3-SiO2 Glass-Ceramics by Sintering

Effect of Nucleation Temperatures and Time on Crystallization Behavior and Properties of Li2O–Al2O3–SiO2 Glasses

The size-effect of Al2O3 on the sinterability, microstructure and properties of glass-alumina composites

Study on Sintering Additive for High Purity Beryllium Oxide Ceramics with High Thermal Conductivity

Sol-Gel Production of Alkaline-Free Aluminosilicate Glass Ceramic and Investigation of its Properties

Crystallization, microstructures and properties of low temperature co-fired CaO-Al 2 O 3 -SiO 2 glass-ceramic

Physical Characteristic and In-Vitro Bioactivity Property of Sintered Glasses made via Sol-Gel and Powder Sintering Process

Microstructure, Thermal, Mechanical, and Dielectric Properties of BaO–CaO–Al2O3–B2O3–SiO2 Glass-Ceramics

Microstructure and Dielectric Properties of Ca-Al-B-Si-O Glass/Al2o3 Composites with Various Alkali Oxides Contents

Investigation on Crystallization Behavior of Y2O3-Al2O3-SiO2 Glass Prepared by High-gravity Combustion Synthesis