Abstract:Since 2002, ultra wideband (UWB) technology has ignited the interests of academia and industry for its potential of achieving high-speed wireless communication in short distance with low power. It is actively investigated today due to the wide available bandwidth for very high data rate up to 480Mb/s and low power service over short distances in 10m range. According to FCC (Federal Communications Commission), the frequency spectrum allocated for UWB is 3.1-10.6 GHz, and the spectrum shape of modulated output power and maximum power level are limited to -41.3dBm/MHz, which ensures that UWB can coexist with existing spectrum users like GSM(Global System of Mobile communication), WLAN(Wireless Local Area Network) and Bluetooth. Based on MB-OFDM(Multi-Band Orthogonal Frequency Division Multiplexing), WiMedia released the initial version of Physical Layer (PHY) Specification in September 2005. In this proposal, the UWB frequency spectrum from 3.1 GHz to 10.6 GHz is divided into 14 channels with 528MHz for each channel. These sub-bands are grouped into five band groups. It is seen that by increasing the signal bandwidth significantly, ultra-wideband achieves a high channel capacity and becomes an attractive solution to the ever-increasing data rate demands in wireless personal area networks (WPAN). In December 2005, European Computer Manufacturer's Association (ECMA) proposed the standard ECMA 368/369 on high-speed UWB physics layer and media access control layer based on MBOFDM scheme. This has pushed the industrialization of UWB technology to a new stage again. In China, UWB technology has also become a hot topic according to the issue of the UWB standard by Chinese Government in 2008. A new UWB scheme named dual carrierorthogonal frequency division multiplexing (DC-OFDM ) has been proposed and applied in China. In China standard, only the band from 6.2GHz to 9.4GHz and the band from 4.2GHz to 4.8GHz are available for UWB applications. These bands are partitioned into 14 subbands of 264MHz bandwidth which means the bandwidth is halved in China’s DC-OFDM standard compared with the ECMA 368/369 standard. Thus the sampling frequency of the DACs(Digital-to-Analog Converter) and ADCs(Analog-to-Digital Converter) are halved too. The power consumption of the system can be reduced greatly. Moreover, in DC-OFDM

Design of a Mmwave Digital Baseband Receiver Integrated with WOLA-CP-OFDM Technique.

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

The Design and Hardware Implementation of OFDM System Receiver Based on FPGA

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

An improved multicarrier based waveform design for cognitive radio communication

An 8X-Parallelism Memory Access Reordering Polyphase Network for 60 GHz FBMC-OQAM Baseband Receiver

Dual-Mode All-Digital Baseband Receiver with a Feed-Forward and Shared-Memory Architecture for Dual-Standard over 60 GHz NLOS Channel

Efficient Adaptive Array Receiver for OFDM Based Wireless Local Area Networks (WLAN)

Design and DSP Realization of an OFDM Receiver

A novel OFDM-PON architecture using single-sideband subcarrier multiplexing

All-in-One Dual-Polarization Waveguide Receiver for Multichannel Wireless Systems

A Power-Area-Efficient, 3-Band, 2-Rx Mimo, Td-Lte Receiver With Direct-Coupled Adc

A Fully Integrated 60ghz Four Channel CMOS Receiver with 7ghz Ultra-Wide Bandwidth for IEEE 802.11ad Standard

2X-Oversampled Receiver Design for CP-FBMA Based Air Interface

Design of 28 GHz 64-QAM Digital Receiver

3 A 0 . 13 Um CMOS 6-9 GHz 9-Bands Double-Carrier OFDM Transceiver for Ultra Wideband Applications

HRO-OFDM Scheme Design and Optimization for a Hybrid RF/VLC Baseband System

IA-OPD: an Optimized Orthogonal Pulse Design Scheme for Waveform Division Multiple Access UWB Systems

Frequency Domain Cooperative Waveform Design Method for Short Baseline Transceiver

A Low-Power Reconfigurable Multi-Band Sliding-If Transceiver For Wban Hubs In 0.18 Mu M Cmos

A Fully-Integrated Reconfigurable Dual-Band Transceiver for Short Range Wireless Communications in 180 Nm CMOS.