Effect of the Laser Cladding Parameters on Microstructure and Elevated Temperature Wear of FeCrNiTiZr Coatings
Yali Gao,Sicheng Bai,Shan Jiang,Pengyong Lu,Dongdong Zhang,Meng Jie,Yu Liu
DOI: https://doi.org/10.3390/ma17184444
IF: 3.4
2024-09-11
Materials
Abstract:In order to prepare coating with good friction and wear resistance at elevated temperature on the surface of hot-working tool steel, by using a CO2 laser, FeCrNiTiZr high-entropy alloy coating with different laser scanning speeds (360, 480 and 600 mm/min, respectively) was successfully fabricated by using laser cladding technology on the surface of H13 steel in this paper. Phase constitutions, microhardness, microstructure, and wear characteristics of FeCrNiTiZr coatings under different laser scanning speeds were analyzed. It was determined that 480 mm/min was the optimal laser scanning speed. The results showed that the coating at the scanning speed of 480 mm/min consists of a BCC phase with significant lattice distortion and high dislocation density; the crystal structure is cellular crystal and dendrite crystal. The coating demonstrates the highest microhardness (842 HV0.2), which is 4.2 times that of the substrate (200 HV0.2). Its average friction coefficients at room temperature and 823 K are approximately one-seventh and one-third of the substrate's, respectively, and its wear volume is reduced by about 98% and 81% under these conditions. Compared to the substrate, the coating underwent slight abrasive wear, adhesive wear, and oxidative wear at both room temperature and 823 K. In contrast, the substrate underwent severe abrasive wear, adhesive wear, oxidative wear, and even fatigue wear.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering