Abstract:The response of metals and their microstructures under extreme dynamic conditions can be markedly different from that under quasistatic conditions. Traditionally, high strain rates and shock stresses are measured using cumbersome and expensive methods such as the Kolsky bar or large spall experiments. These methods are low throughput and do not facilitate high-fidelity microstructure-property linkages. In this work, we combine two powerful small-scale testing methods, custom nanoindentation, and laser-driven micro-flyer shock, to measure the dynamic and spall strength of metals. The nanoindentation system is configured to test samples from quasistatic to dynamic strain rate regimes (10$^{-3}$ s$^{-1}$ to 10$^{+4}$ s$^{-1}$). The laser-driven micro-flyer shock system can test samples through impact loading between 10$^{+5}$ s$^{-1}$ to 10$^{+7}$ s$^{-1}$ strain rates, triggering spall failure. The model material used for testing is Magnesium alloys, which are lightweight, possess high-specific strengths and have historically been challenging to design and strengthen due to their mechanical anisotropy. Here, we modulate their microstructure by adding or removing precipitates to demonstrate interesting upticks in strain rate sensitivity and evolution of dynamic strength. At high shock loading rates, we unravel an interesting paradigm where the spall strength of these materials converges, but the failure mechanisms are markedly different. Peak aging, considered to be a standard method to strengthen metallic alloys, causes catastrophic failure, faring much worse than solutionized alloys. Our high throughput testing framework not only quantifies strength but also teases out unexplored failure mechanisms at extreme strain rates, providing valuable insights for the rapid design and improvement of metals for extreme environments.

Improved shock-reloading technique for dynamic yield strength measurements

Investigation of dynamic response of brittle materials under high-rate loading

Experimental Investigation on the Enhancing Effect of Reactive Materials on Explosion Fireballs and Shock Waves of Composite Charges

Effect of shock-induced substructure evolution on the dynamic reloading mechanical behavior of Ti-17 alloy

Experimental Measurements of 2169 Stainless-Steel under Dynamic Loading

A unified method for studying impact particle relation and spallation under shock loading

Rapid Quantification of Dynamic and Spall Strength of Metals Across Strain Rates

Measuring the strength of ductile microparticles at extreme strain rates

Research on mechanical response of Ti6321 titanium alloy after shocked by light gas gun

Reducing the Rebound Effect in Microscale Laser Dynamic Forming through Multi-Pulse Laser Shock Loading

Improving the damage potential of W-Zr reactive structure material under extreme loading condition

The experimental and numerical study of AA6061-T6 aluminum alloy under repeated impacts

Influence of impact velocity on impact-initiated reaction behavior of Zr-Ti-Nb alloy

An Improved Calibration of Karagozian & Case Concrete/cementitious Model for Strain-Hardening Fibre-Reinforced Cementitious Composites under Explosion and Penetration Loadings

Constitutive Behavior and Ballistic Performance of Aerospace 2A16 Aluminum Alloy under Different Impact Velocities

System Ringing in Impact Test Triggered by Upper-and-lower Yield Points of Materials

Investigation on Dynamic Hardness and High Strain Rate Indentation Size Effects in Aluminium (110) Using Nano-Impact

Surface Mechanical Property and Residual Stress Stability of Shot-Peened Mg-8Gd-3Y Alloy by In-Situ X-ray Diffraction

Determination of the Mechanical Properties of Metals at Very High Strain Rates

Application of ramp-wave loading for spallation tests using a graded generalized impedance flyer

Characterization of Dynamic Mechanical Properties of LY100, LY160 Low-Yield-point Steels