Abstract:The response of metals and their microstructures under extreme dynamic conditions can be markedly different from that under quasistatic conditions. Traditionally, high strain rates and shock stresses are measured using cumbersome and expensive methods such as the Kolsky bar or large spall experiments. These methods are low throughput and do not facilitate high-fidelity microstructure-property linkages. In this work, we combine two powerful small-scale testing methods, custom nanoindentation, and laser-driven micro-flyer shock, to measure the dynamic and spall strength of metals. The nanoindentation system is configured to test samples from quasistatic to dynamic strain rate regimes (10$^{-3}$ s$^{-1}$ to 10$^{+4}$ s$^{-1}$). The laser-driven micro-flyer shock system can test samples through impact loading between 10$^{+5}$ s$^{-1}$ to 10$^{+7}$ s$^{-1}$ strain rates, triggering spall failure. The model material used for testing is Magnesium alloys, which are lightweight, possess high-specific strengths and have historically been challenging to design and strengthen due to their mechanical anisotropy. Here, we modulate their microstructure by adding or removing precipitates to demonstrate interesting upticks in strain rate sensitivity and evolution of dynamic strength. At high shock loading rates, we unravel an interesting paradigm where the spall strength of these materials converges, but the failure mechanisms are markedly different. Peak aging, considered to be a standard method to strengthen metallic alloys, causes catastrophic failure, faring much worse than solutionized alloys. Our high throughput testing framework not only quantifies strength but also teases out unexplored failure mechanisms at extreme strain rates, providing valuable insights for the rapid design and improvement of metals for extreme environments.

Measuring the strength of ductile microparticles at extreme strain rates

Investigation of dynamic response of brittle materials under high-rate loading

Analysis of fragment size and ejection velocity at high strain rate

Achieving High Strength and High Ductility in Nanostructured Metals: Experiment and Modelling

Investigation of fatigue mechanical properties of apolycrystalline solid at mesoscopic scale using depth-sensing indentation (DSI) technique

Dynamic Fracture in Brittle Solids at High Rates of Loading

A high-rate, impact-driven biaxial fragmentation experiment for ductile materials

Identification of material parameters at high strain rates using ballistic impact tests and inverse finite element analysis

Rapid Quantification of Dynamic and Spall Strength of Metals Across Strain Rates

Particle breakage of calcareous sand from low-high strain rates

High Strain Rate Compressive Deformation Behavior of Nickel Microparticles

Multiscale Richtmyer-Meshkov instability experiments to isolate the strain rate dependence of strength

A rate-dependent damage mechanics model for predicting plasticity and ductile fracture behavior of sheet metals at high strain rates

Device and method for investigation of mechanical properties of the materials under high-strain rate tensile load

Explosion/impact Response of Pure Molybdenum at Ultra-High Strain Rate and Large Strains

Multiscale Simulation Study on the Spallation Characteristics of Ductile Metal Ta under High Strain Rate Impact

Measurement of Dynamic Fracture Parameters in the Expansion Process at High Strain Rate

Dynamic Hardness Evolution in Metals from Impact Induced Gradient Dislocation Density

A new technique to measure the dynamic fracture toughness of solids

Mechanochemically responsive polymer enables shockwave visualization

Quantifying Dislocation Drag at High Strain Rates with Laser-Induced Microprojectile Impact