Abstract:Good gas permeability is an essential factor for the smooth operation and high performance in the lower part of the blast furnace. Under the present low carbon blast furnace smelting conditions, the coke layer is thinner, and the proportion of the molten metal in the coke layer is significantly higher, resulting in a major reduction in gas permeability, which seriously affects blast furnace operations. Also, the lower thickness of the coke layer weakens the process of solid-liquid carbon dissolution when the molten iron passes through the coke layer, which reduces the carbon content of the molten iron and further deepens the erosion of the refractory by the unsaturated molten iron. The carbon dissolution in the molten iron in a blast furnace core was measured by a high-temperature vacuum wettability test tool that analyzed the interface wetting activity between Fe−C melts with specific carbon mass fraction (3.8%, 4.3%, 4.8%) and 99.9% of high temperatures graphite plates. Besides, the scanning electron microscope (SEM) and energy dispersive spectroscopy (EDS) were used to analyze the graphite substrate’s carburizing morphology and carburizing distances. The results show that, with the increase of carbon content, the interface contact angle becomes bigger. The contact angle decreases with time, and eventually reaches a steady-state during the melting process, and the Fe−C melt with saturated carbon cannot be wet. The scanning electron microscopy analysis shows that a spherical cap-like depression is created by a cross-section of the Fe−C melt and the graphite substrate, and the radius and volume of the depression decrease with increasing carbon content. The study of the EDS scanning analysis shows that the amount of dissolved carbon atoms in the graphite substrate penetrates the Fe−C melt and decreases with increasing initial carbon concentration. The smaller the carburizing effect, the better the wetting is conducive to carbon mass transfer. It is found that by measuring carburizing of the carbon atoms in the graphite substrate into the Fe−C melt by calculating the surface energy reduces the surface energy between the two. Thus, the surface tension decreases and the melt spreads slowly with contact angle gradually decreasing during melting.

Highly Reactive Coke Made from Low-rank Coal: Relationship Between Thermal Properties and Multilevel Structure

Evolution of Coke Microstructure and Metallurgical Properties During Graphitization in a Blast Furnace

Application of High‐ and Low‐Reactivity Cokes in Hydrogen‐Rich Blast Furnaces

Characterization of gasification-coke prepared with coal by-product and a high ratio of low-rank coal addition

Optimizing the performance of iron coke by coal blending: Insights from the metallurgical properties and structural characteristics

Effect of blast furnace coke graphitizing its high temperature metallurgical properties

Physical and chemical properties of metallurgical coke and its evolution in the blast furnace ironmaking process

Metallurgical Coke Combustion with Different Reactivity under Nonisothermal Conditions: A Kinetic Study

Impact of Chemical Structure of Coal on Coke Quality Produced by Coals in the Similar Category

Clean Preparation of Formed Coke from Semi-coke by the Carbonated Consolidation Process

Degradation Behaviors of Coke under Complex Solution Loss Conditions

Effect of binder composition on the preparation of formed coke with low-rank coal

Effect of high temperature on macroscopic properties and microstructure of metallurgical coke

Catalytic Effect of Alkali Metals on the Gasification Dissolution Reaction and Deep Reaction Behavior of Metallurgical Cokes.

Interface Wetting Behavior Between Iron and Coke During the Carbon Dissolution Process in a Blast Furnace

Relevance between various phenomena during coking coal carbonization. Part 4: Insight into the interaction of coal blending

Coupled Typical Coke Gasification and Sintering Ore Reduction in CO–N2–H2

Production of highly reactive cokes by adding alkali metals and alkaline earth metals and their effect mechanism

Study on the interaction and coking characteristics of low-sulfur meager coal and medium-high sulfur fat coal during co-carbonization process

The evolution of pore structure during coke graphitization process in the blast furnace hearth

Effects of Microscopic Characteristics on Post-Reaction Strength of Coke