Abstract:The ability to model the cyclic behavior of low yield point steel accurately is essential for its application to seismic design. In this study, uniaxial tests of monotonic and strain controlled cyclic loading are conducted to investigate the mechanical properties of the low yield point steel BLY160. As observed in the test, work-hardening is an important hysteretic characteristic, which significantly influences the energy dissipation capacity of the steel. However, the cyclic softening in both stiffness and stress evolve as the plastic strain accumulates, which is manifested in the decrease of both the stress amplitude and the elastic domain of the stress–strain hysteresis loops. This change in the shape of the cyclic loops is called the “flattening effect” in this paper. To describe the cyclic hardening and softening effect by using one unified set of material parameters, a more sophisticated model based on the concept of internal variables is proposed as an extension of the combined isotropic-kinematic hardening model. The novel idea of a “transformation zone” with the introduction of an additional internal variable is proposed to synchronize the updates of isotropic and kinematic hardening such that the simultaneous change in the stress amplitude and the elastic region can be reproduced. Note that the cyclic softening develops in three stages: incubation, growth and the stabilization period. The logistic function, which presents a curve with an “S” shape, is first used to trace the evolution of the softening. Finally, the model parameters are identified by the test data, and the accuracy of the proposed model is verified by comparing the simulated performance and the experimental response under different loading histories. The results demonstrate that the extended model can elaborately describe the evolutional processes of cyclic hardening and softening by incorporating characteristics, such as the nonlinear transient behavior from elastic to plastic status, early yield under reversed loading and strain history dependence.

An Anomalous Compression-Induced Softening Behavior of AA6014-T4P During Cyclic Loading

Research on the 2A11 Aluminum Alloy Sheet Cyclic Tension–Compression Test and Its Application in a Mixed Hardening Model

Modeling of Low Cycle Behavior of P92 Steel Based on Cyclic Plasticity Constitutive Equations

An experimental and modelling study of cyclic tension-compression behavior of AA7075-T6 under electrically-assisted condition

Cyclic Hardening and Softening Behavior of the Low Yield Point Steel BLY160: Experimental Response and Constitutive Modeling

Mechanical responses of in-situ TiB2/7050 composite subjected to monotonic and cyclic loadings: A comparative study with 7050-Al

Cyclic deformation and dynamically induced short-range ordering in small particles reinforced Al composite

Cyclic hardening and softening behavior of the low yield point steel: Implementation and validation

Study on Constitutive Model of Cyclic Elastoplastic Behavior of 6082-T6 Aluminum Alloy

Characterization of kinematic and distortional hardening by cyclic twin-bridge shear tests for sheet metal with inverse engineering approach

Cyclic softening behavior of structural steel with strain range dependence

Experimental Investigation and FE Analysis on Constitutive Relationship of High Strength Aluminum Alloy under Cyclic Loading

Constitutive Modeling on Cyclic Stress-Strain Behaviour of 7A04-T6 High-Strength Aluminium Alloy

Constitutive model for cyclic behavior of mild steel under various strain amplitudes

Prediction of Work-Hardening Behavior under Various Loading Paths in 5083-O Aluminum Alloy Sheet Using Crystal Plasticity Models

Analysis of ductile damage and fracture under reverse loading

Investigation of Yield Surfaces Evolution for Polycrystalline Aluminum after Pre-Cyclic Loading by Experiment and Crystal Plasticity Simulation

Characterization and modelling of evolving plasticity behaviour up to fracture for FCC and BCC metals

A modified damage-coupled viscoplastic constitutive model for capturing the asymmetric behavior of a nickel-based superalloy under wide creep-fatigue loadings

Material modeling of 6016-O and 6016-T4 aluminum alloy sheets and application to hole expansion forming simulation

Strain amplitude-dependent cyclic softening behavior of carbide-free bainitic rail steel: Experiments and modeling