Abstract:A low-noise Brillouin random fiber laser (BRFL) with stabilized lasing output and narrow linewidth is proposed and demonstrated experimentally. Stimulated Brillouin scattering and Rayleigh scattering are exploited to work as the gain and random distributed feedback mechanisms, respectively. A simple unpumped Erbium-doped fiber (EDF) loop structure which consists of a section of EDF and an optical coupler is introduced into the BRFL cavity, forming a saturable absorption ring (SAR). When light with proper intensity is incident into the SAR, a dynamic fiber grating (DFG) can be built up to work as a narrow-bandwidth filter with the ability of auto-tracking the center frequency. The SAR can effectively filter out dense random longitudinal modes and suppress multi-mode resonances and frequency jitters by restricting the mode-competition-induced mode hopping within a limited frequency range of ∼ 1 MHz and auto-tracking the center frequency of light in the cavity, simultaneously. Thus, the output of BRFL with SAR is much more stabilized than existing free-running BRFLs. In the experiment, a stable lasing output with an ultra-narrow linewidth (less than2kHz) is obtained from the proposed BRFL. The measured relative intensity noise and frequency noise demonstrate that the noise level of the proposed laser is significantly lower than that of the free-running BRFLs. This proposed technique not only provides a solution to the dilemma of previously reported BRFLs with severe lasing instabilities, but also makes a step towards the development of practical and reliable BRFLs. This high-quality laser source with advantages of high stability, low cost, low threshold power, high coherence, narrow linewidth, and low noise can find useful applications in coherent optical detection, high-resolution spectrometers, microwave photonics, and optical sensing fields.

Brillouin Laser Based on High <i>Q</i> Fiber Ring Resonator

Stabilized Narrow-Linewidth Brillouin Random Fiber Laser With a Double-Coupler Fiber Ring Resonator

Two-Frequency Brillouin Fiber Laser Based on Bragg Grating Fabry-Perot Cavity

Kilohertz-Linewidth Brillouin Photonic Crystal Fiber Laser With Non-Resonance Pumping Configuration

Single-frequency Brillouin lasing based on a birefringent fiber Fabry–Pérot cavity

Hertz-Level Linewidth Brillouin Fiber Laser Using Doubly Resonant Cavities

Low-noise Brillouin random fiber laser with Auto-tracking dynamic fiber grating based on a saturable absorption ring

Highly stable Brillouin laser with controllable tuning based on fiber ring resonator

Stabilized Brillouin laser with sub-Hz fundamental linewidth aided by frequency shifted optical injection locking

Noise-squeezed forward Brillouin lasers in multimode fiber microresonators

Pump-locked microcavity Brillouin laser

Stabilized single-frequency sub-kHz linewidth Brillouin fiber laser cavity operating at 1 µm

High Order Cascaded Raman Random Fiber Laser with High Spectral Purity

Sub-kHz high-order mode Brillouin random fiber laser based on long-period fiber grating and distributed Rayleigh scattering in a half-open linear cavity

Neodymium laser-pumped ultra-low noise tunable Brillouin fiber laser around 920 nm

Sub-kilohertz intrinsic linewidth stimulated Brillouin laser in integrated lithium niobate microresonators

Broadband Brillouin Slow Light Based on Multifrequency Phase Modulation in Optical Fibers

A narrow-linewidth high-power fused silica Brillouin laser

589 nm laser generation by frequency doubling of a single-frequency Raman fiber amplifier in PPSLT.

Distributed Feedback Fiber Laser Employing Brillouin Gain

Brillouin Fiber Laser Based on Photonic Crystal Fiber