Abstract:A low-noise Brillouin random fiber laser (BRFL) with stabilized lasing output and narrow linewidth is proposed and demonstrated experimentally. Stimulated Brillouin scattering and Rayleigh scattering are exploited to work as the gain and random distributed feedback mechanisms, respectively. A simple unpumped Erbium-doped fiber (EDF) loop structure which consists of a section of EDF and an optical coupler is introduced into the BRFL cavity, forming a saturable absorption ring (SAR). When light with proper intensity is incident into the SAR, a dynamic fiber grating (DFG) can be built up to work as a narrow-bandwidth filter with the ability of auto-tracking the center frequency. The SAR can effectively filter out dense random longitudinal modes and suppress multi-mode resonances and frequency jitters by restricting the mode-competition-induced mode hopping within a limited frequency range of ∼ 1 MHz and auto-tracking the center frequency of light in the cavity, simultaneously. Thus, the output of BRFL with SAR is much more stabilized than existing free-running BRFLs. In the experiment, a stable lasing output with an ultra-narrow linewidth (less than2kHz) is obtained from the proposed BRFL. The measured relative intensity noise and frequency noise demonstrate that the noise level of the proposed laser is significantly lower than that of the free-running BRFLs. This proposed technique not only provides a solution to the dilemma of previously reported BRFLs with severe lasing instabilities, but also makes a step towards the development of practical and reliable BRFLs. This high-quality laser source with advantages of high stability, low cost, low threshold power, high coherence, narrow linewidth, and low noise can find useful applications in coherent optical detection, high-resolution spectrometers, microwave photonics, and optical sensing fields.

Sub-kHz high-order mode Brillouin random fiber laser based on long-period fiber grating and distributed Rayleigh scattering in a half-open linear cavity

High-order-mode Brillouin Random Fiber Laser Based on Distributed Rayleigh Scattering in All-Few Mode Fiber Half-Open Cavity

Towards optimal conversion efficiency of Brillouin random fiber lasers in a half-open linear cavity

Dynamic mode-switchable and wavelength-tunable Brillouin random fiber laser by a high-order mode pump

Enhancing frequency stability and mode control in a Brillouin random fiber laser with a strongly scattering disordered grating

Compact single-end pumped Brillouin random fiber laser with enhanced distributed feedback

Single-longitudinal-mode narrow linewidth broadband tunable Brillouin random laser including dispersion compensation fibers

Flat amplitude multiwavelength Brillouin–Raman random fiber laser with a half-open cavity

Low-noise Brillouin random fiber laser with Auto-tracking dynamic fiber grating based on a saturable absorption ring

Two-Frequency Brillouin Fiber Laser Based on Bragg Grating Fabry-Perot Cavity

Stabilizing Brillouin Random Laser with Photon Localization by Feedback of Distributed Random Fiber Grating Array.

Tunable Multi-Wavelength Brillouin-Erbium-Doped Random Fiber Laser

A half-open cavity random fiber laser based on a single-mode fiber and fiber Bragg grating

Self-injection locked low-noise Brillouin random fiber laser via dynamic fiber grating for QAM coherent communication

Random Fabry-Perot resonator-based sub-kHz Brillouin fiber laser to improve spectral resolution in linewidth measurement.

High-Power Random Raman Fiber Laser With an Ultrashort Random Fiber Grating

Narrow-linewidth Q-switched Random Distributed Feedback Fiber Laser.

Stabilized Narrow-Linewidth Brillouin Random Fiber Laser With a Double-Coupler Fiber Ring Resonator

Single-Mode Narrow Linewidth Random Fiber Laser with Enhanced Feedback from Rayleigh Scattering

Single Longitudinal Mode Brillouin Fiber Laser with Cascaded Ring Fabry–Pérot Resonator

Tunable Broadband Multi-Wavelength Brillouin-Raman Random Fiber Laser Based on High-Order Raman Pump