Abstract:Purpose: X-ray fluorescence computed tomography (XFCT) is an emerging molecular imaging modality for preclinical and clinical applications with high atomic number contrast agents. XFCT allows detection of molecular biomarkers at tissue depths of 4-9 mm at L-shell energies and several centimeters for K-shell energies, while maintaining high spatial resolution. This is typically not possible for other molecular imaging modalities. The purpose of this study is to demonstrate XFCT imaging with reduced acquisition times. To accomplish this, x-ray focusing polycapillary optics are utilized to simultaneously increase x-ray fluence rate and spatial resolution in L-shell XFCT imaging. Materials and methods: A prototype imaging system using a polycapillary focusing optic was demonstrated. The optic, which was custom-designed for this prototype, provided a high fluence rate with a focal spot size of 2.6 mm at a source to isocenter distance of 3 cm with a ten times higher fluence rate compared to standard collimation. The study evaluates three different phantoms to explore different trade-offs and limitations of L-shell XFCT imaging. A low-contrast gold phantom and a high-contrast gold phantom, each with three target regions with gold concentrations of 60, 80, and 100 μg ml - 1 for low contrast and 200, 600, and 1000 μg ml - 1 for high contrast, and a mouse-sized water phantom with gold concentrations between 300 and 500 μg ml - 1 were imaged. X-ray fluorescence photons were measured using a silicon drift detector (SDD) with an energy resolution of 180 eV FWHM at an x-ray energy of 11 keV. Images were reconstructed with an iterative image reconstruction algorithm and analyzed for contrast to noise ratio (CNR) and signal to noise ratio (SNR). Results: The XFCT data acquisition could be reduced from 17 h to under 1 h. The polycapillary x-ray optic increases the x-ray fluence rate and lowers the amount of background scatter which leads to reduced imaging time and improved sensitivity. The quantitative analysis of the reconstructed images validates that concentrations of 60 μg ml - 1 of gold can be visualized with L-shell XFCT imaging. For a mouse-sized phantom, a concentration of 300 μg ml - 1 gold was detected within a 66 min measurement. Conclusions: With a high fluence rate pencil beam from a polycapillary x-ray source, a reduction in signal integration time is achieved. It is presented that subtle amounts of contrast agents can be detected with L-shell XFCT within biologically relevant time frames. Our basic measurements show that the polycapillary x-ray source technology is appropriate to realize preclinical L-shell XFCT imaging. The integration of more SDDs into the system will lower the dose and increase the sensitivity.

First results on Compton camera system used for x-ray fluorescence computed tomography

First Demonstration of Compton Camera Used for X-Ray Fluorescence Imaging.

X-ray Fluorescence Compton Imaging Technique Based on a Single-layer Timepix3 Photon-counting Detector

Timepix3-based Single Layer X-ray Fluorescence Compton Camera

Full-fieldin Vivoimaging of Nanoparticles Using Benchtop Cone-Beam XFCT System with Pixelated Photon Counting Detector.

Quantitative Imaging Of Gd Nanoparticles In Mice Using Benchtop Cone-Beam X-Ray Fluorescence Computed Tomography System

New X-ray Fluorescence CT (XFCT) System Using Multi-beam X-ray Source

X-ray fluorescence computed tomography (XFCT) imaging with a superfine pencil beam x-ray source

Full-field Fan-Beam X-Ray Fluorescence Computed Tomography with a Conventional X-Ray Tube and Photon-Counting Detectors for Fast Nanoparticle Bioimaging

Full-field Fan-Beam X-Ray Fluorescence Computed Tomography System Design with Linear-Array Detectors and Pinhole Collimation: a Rapid Monte Carlo Study

Fan-Beam X-Ray Fluorescence Computed Tomography (xfct) with Gold Nanoparticles

Compton imaging using high resolution scintillation detectors

Experimental Demonstration of X-Ray Fluorescence CT Using a Spatially Distributed Multi-Beam X-Ray Source

Monte Carlo Simulation for Polychromatic X-ray Fluorescence Computed Tomography with Sheet-Beam Geometry

Review of Compton camera imaging technology development

XFCT imaging system with pinhole collimation and attenuation correction

High-sensitivity and spatial resolution benchtop cone beam XFCT imaging system with pixelated photon counting detectors using enhanced multipixel events correction method

Simultaneous X-Ray Fluorescence and K-edge CT Imaging with Photon-Counting Detectors

Linearly Polarized X-ray Fluorescence Computed Tomography Based on a Thomson Scattering Light Source: a Monte Carlo Study.

A Portable Three-Layer Compton Camera for Wide-Energy-Range Gamma-ray Imaging: Design, Simulation and Preliminary Testing

Reduced acquisition time for L-shell x-ray fluorescence computed tomography using polycapillary x-ray optics