Abstract:A series of MnCo/Cu-ZSM-5 (MnCo/Cu-Z) catalysts with different Mn/Co ratios for the selective catalytic reduction (SCR) of NO with NH3 were prepared by the combination of ion exchange and impregnation. The physicochemical properties of the catalysts were investigated by N2 adsorption/desorption, X-ray diffraction (XRD), temperature-programmed reduction with hydrogen (H2-TPR), X-ray photoelectron spectroscopy (XPS), and temperature-programmed desorption of NOx (NOx-TPD) and NH3 (NH3-TPD), and the diffuse reflectance infrared Fourier transform (DRIFT) technique was employed for the detection of intermediate species and the study of the mechanism. The introduction of Mn and Co boosts the catalytic activity of the Cu-Z catalyst at a temperature below 200 °C, and the optimum activity was obtained over the Mn1Co2/Cu-Z catalyst. The enrichment of the high-valent metal ion on the catalyst surface and the improvement in the reducibility of metal oxide are responsible for the elevation in the catalytic activity of MnCo/Cu-Z. The bridged and bidentate modes are the prevailing nitrate species on the Cu-Z and MnCo/Z catalysts, respectively, and both of them were detected over the MnCo/Cu-Z catalyst. Furthermore, the DRIFT spectroscopy (DRIFTS) results indicate that, at 150 °C, the bridged nitrate can react with the adsorbed ammonia species, but the bidentate nitrate fails to do. The SCR reaction over the Cu-Z catalyst follows the Eley–Rideal and Langmuir–Hinshelwood mechanisms simultaneously at 150 °C, whereas an overwhelming dominance of the Eley–Rideal mechanism is identified for the MnCo/Z catalyst. As to the SCR mechanism on the MnCo/Cu-Z catalyst, it combines the features of Cu/Z and Mn1Co2/Z.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acscatal.1c01172?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acscatal.1c01172</a>.Physical properties of catalysts; peak positions and assignments in the DRIFT Spectra; effects of H2O on NOx conversion; effects of H2O on the stability of catalysts; EDS element mapping of catalysts; and relative amount of surface acid sites (<a class="ext-link" href="/doi/suppl/10.1021/acscatal.1c01172/suppl_file/cs1c01172_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Phosphotungstic Acid-Modified MnO<sub>x</sub> for Selective Catalytic Reduction of NO<sub>x</sub> with NH<sub>3</sub>

Phosphotungstic Acid-Modified MnOx for Selective Catalytic Reduction of NOx with NH3

H3pw12o40-Modified Mnox: Efficient Catalyst for Nh3-Scr of Nox

Unveiling the temperature-dependent effect of Zn on phosphotungstic acid-modified MnOx catalyst for selective catalytic reduction of NOx: A poison at 180 C or a promoter at 180 C

Promoting Effect of Polyoxometallic Acid Modification on the NH3-SCR Performance of Mn-Based Catalysts

Spinel Structured CoaMnbOx Mixed Oxide Catalyst for the Selective Catalytic Reduction of NOx with NH3

Enhanced sulfur resistance of H3PW12O40-modified Fe2O3 catalyst for NH3-SCR: Synergistic effect of surface acidity and oxidation ability

Promoting effect of polyoxometallic acid modification on the NH 3 -SCR performance of Mn-based catalysts

Eu-Mn-Ti Mixed Oxides for the SCR of NOx with NH3: the Effects of Eu-modification on Catalytic Performance and Mechanism

Manganese Oxide Catalysts Supported on Zinc Oxide Nanorod Arrays: A New Composite for Selective Catalytic Reduction of NOx with NH3 at Low Temperature

Manganese–niobium Mixed Oxide Catalyst for the Selective Catalytic Reduction of NOx with NH3 at Low Temperatures

Thulium Modified MnOx/TiO2 Catalyst for the Low-Temperature Selective Catalytic Reduction of NO with Ammonia

Manganese Oxide Nanorod Catalysts for Low-Temperature Selective Catalytic Reduction of NO with NH3

Mineral-derived Catalysts Optimized for Selective Catalytic Reduction of NOx with NH3

Cu-ZSM-5 Catalyst Impregnated with Mn–Co Oxide for the Selected Catalytic Reduction of NO: Physicochemical Property–Catalytic Activity Relationship and In Situ DRIFTS Study for the Reaction Mechanism

Titania-Samarium-Manganese Composite Oxide for the Low-Temperature Selective Catalytic Reduction of NO with NH3

Sm-MnOx Catalysts for Low-Temperature Selective Catalytic Reduction of NOx with NH3:Effect of Precipitation Agent

The Role of NH_3 in the Low-Temperature Selective Catalytic Reduction of NO over MnO_x/TiO_2

Ni-Mn Bi-Metal Oxide Catalysts for the Low Temperature SCR Removal of NO with NH3

A High-Performance Mn/TiO2 Catalyst with a High Solid Content for Selective Catalytic Reduction of NO at Low-Temperatures

Selective Catalytic Reduction of NO with NH3 over Mn–Fe/USY under Lean Burn Conditions