Abstract:In this article, a numerical investigation of the flow and heat transfer in a three-row finned-tube heat exchanger is conducted with a three-dimensional laminar conjugated model. Four types of fin surfaces are studied; one is the whole plain plate fin, and the other three are of slotted type, called slit 1, slit 2, and slit 3. All four fin surfaces have the same global geometry dimensions. The three slotted fin surfaces have the same numbers of strips, which protrude upward and downward alternatively and are positioned along the flow direction according to the rule of "front coarse and rear dense.'' The difference in the three slotted fins is in the degree of "coarse'' and "dense'' along the flow direction. Numerical results show that, compared to the plain plate fin, the three types of slotted fin all have very good heat transfer performance in that the percentage increase in heat transfer is higher than that in the friction factor. Among the three slotted fin surfaces, slit 1 behaves the best, followed by slit 2 and slit 3 in order. Within the Reynolds number range compared ( from 2,100 to 13,500), the Nusselt number of slit 1 is about 112-48% higher than that of the plain plate fin surface under the identical pumping constraint. An analysis of the essence of heat transfer enhancement is conducted from the field synergy principle, which says that the reduction of the intersection angle between the velocity and the temperature gradient is the basic mechanism for enhancing convective heat transfer. It is found that for the three comparison constraints the domain-average synergy angle of slit 1 is always the smallest, while that of the plain plate fin is the largest, with slit 2 and slit 3 being somewhat in between. The results of the present study once again show the feasibility of the field synergy principle and are helpful to the development of new types of enhanced heat transfer surfaces.

Numerical Investigation of Slit Fin at Different Reynolds Numbers: A Sensitivity Analysis and Optimization by Taguchi Methodology

A Numerical Study on the Air-Side Heat Transfer of Perforated Finned-Tube Heat Exchangers with Large Fin Pitches

NUMERICAL INVESTIGATION ON THE EFFECTS OF SLOTTED HEIGHT ON PERFORMANCE OF LOUVER AND SLIT FINS AT DIFFERENT FIN PITCHES

Parametric Study and Optimization of H-type Finned Tube Heat Exchangers Using Taguchi Method

Numerical Design of Efficient Slit Fin Surfaces with Strips in Different Directions

Parametric Study and Field Synergy Principle Analysis of H-type Finned Tube Bank with 10 Rows

TAGUCHI INVESTIGATION OF PARAMETRIC STUDY ON THE PERFORMANCE OF INTERNALLY LONGITUDINALLY FINNED TUBE WITH SINUSOIDAL WAVY FIN

A New Performance Evaluation Method and Its Application in Fin-Tube Surface Design of Small Diameter Tube

Numerical simulation of slit fin cell's flow and heat transfer

Parametrical Research in Offset Strip Fin Performance at Low Reynolds Number

NUMERICAL DESIGN OF EFFICIENT SLOTTED FIN SURFACE BASED ON THE FIELD SYNERGY PRINCIPLE

Field Synergy Analysis of Heat Transfer Enhancement on Slit Wavy Fins

Numerical Study on Performance Optimization of H-type Finned Tubes

Prediction and analysis of thermal-hydraulic performance with slit fins in small diameter (3 mm to 4 mm) heat exchangers

Numerical investigation to analyse the effect of fin shape on performance of finned tube heat exchanger

Numerical analysis and optimization on flow and heat transfer performance of HPD‐type perforated fins

Numerical simulation and field synergy analysis of heat transfer performance of radial slit fin surface

Numerical simulation of heat transfer and flow characteristics for plate fin-and-tube heat exchanger with ring-bridge slit fins

Sobol Sensitivity Analysis for Governing Variables in Design of a Plate-Fin Heat Exchanger with Serrated Fins

Parametric Study and Optimization of Cast Al-Si Alloy Heat Exchanger Using Taguchi Method

3D Numerical Simulation of the Air Flow Among the Multi-louvered Fins