Abstract:Light detection and ranging (LiDAR) is the most important active remote sensing tool and is widely used in civilian and military fields. There are a number of methods to drive laser diodes; the most common circuit topologies are capacitor-discharge resonant circuits. However, the performance of the silicon (Si)-based switching device limits the development of Light detection and ranging, such as the large figure of merit (FOM) and the stray inductance. Although different methods have been reported to resolve these problems, there are still great challenges in reducing the pressure on Light detection and ranging driver design. Hence, this work presents a gallium nitride (GaN)–Si hybrid integrated driver for a Light detection and ranging system. In the circuit, the switching power device uses GaN instead of a Si-based device, because GaN enables much better performance for pulsed-laser operation due to its near-ideal switching performance. Furthermore, a GaN push–pull driver stage between the GaN power device and the Si-based driver integrated circuit (IC) was innovatively introduced, which is integrated in the same chip with the GaN power device, thereby effectively reducing the parasitic parameters of the signal chain and enhancing the system reliability. The design and implementation of the Si-based IC and GaN IC are based on 0.18 μm 80–120 V Bipolar-CMOS-DMOS (BCD) technology and 0.5 μm p-GaN technology, respectively. The experimental results suggest that the proposed driver circuit output pulse width is 12.6 ns, and it can normally operate at 10 MHz with turn-on/turn-off delay is 11.94 ns. In addition, the driver was capable of generating approximately 8.25 A current pulses through a low ohmic load with a pulse width of approximately 12.4 ns. This work plays a vital role in promoting the development of information equipment and aerospace equipment such as precise ranging, high-efficiency power supplies, and high-speed motors.

A Fully-integrated GaN Driver for Time-of-flight Lidar Applications

A GaN–Si hybrid integrated driver for narrow-pulse and high-current LiDAR applications

A Tri-Slope Gate Driving GaN DC–DC Converter with Spurious Noise Compression and Ringing Suppression for Automotive Applications

Optimization of System Design and Calibration Algorithm for SPAD-Based LiDAR Imager

Modulated High Power and Narrow Pulse Width Laser Drive Circuit for Lidar System

A 50-Ps Gated VCRO-Based TDC with Compact Phase Interpolators for Flash LiDAR

A 16-Channel Analog CMOS SiPM with On-Chip Front-End for D-ToF LiDAR

Fully integrated free-running InGaAs/InP single-photon detector for accurate lidar applications

An Integrated 200mhz 4A Pulsed Laser Driver with DLL-Based Time Interpolator for Indirect Time-of-Flight Applications.

Low-Timing-Jitter GHz-Gated InGaAs/InP Single-Photon Avalanche Photodiode for LIDAR

Monolithic GaN-Based Driver and GaN Switch With Diode-Emulated GaN Technique for 50-MHz Operation and Sub-0.2-ns Deadtime Control

Photonic-electronic integrated circuit-based coherent LiDAR engine

High-power 910 Nm Vertical-Cavity Surface-Emitting Laser Arrays for Light Detection and Ranging

A Pulsed-Coherent Lidar With Sub-10 μm Precision

A nanosecond pulsed CMOS LED for all-silicon time-of-flight ranging

A High-Speed Low Side GaN E-Hemt Driver with Gate Ringing and Overshoot Suppression.

High-Power Narrow-Pulse Width VCSEL Array Laser Source for Flash LiDAR

Down-scaling of GaN-based Laser Diodes for High-Speed Modulation Characteristics

A Load-Adaptive Driving Method for a Quasi-Continuous-Wave Laser Diode

A Low-Cost High-Resolution Solid-State Lidar With Wavelength Division Multiplexed Components and Interleaved Orthogonal Polarization Grating Couplers

High-speed GaN-based Laser Diode with Modulation Bandwidth Exceeding 5 GHz for 20 Gbps Visible Light Communication