Abstract:At present, alloys are affected by various stress states during their deformation process. Various stresses can facilitate alloy deformation at the same time, and the influence of these stresses on material deformation is difficult to clarify. It is essential to clarify the difference in the deformation mechanism of an alloy in a single stress state In this work, the internal deformation mechanism of the Mg-13Gd-4Y-2Zn-0.5Zr alloy under two stress states at different deformation temperatures was studied by compression and torsion experiments. The results show that the grain is slightly deformed under shear stress deformation, and the long period stacking ordered (LPSO) phases of different forms show smaller kink angles, fewer kink times, and larger relative width ratios of the kink bands. Under compressive stress deformation, the grain is obviously compressed along the CD direction and presents a streamline, and the LPSO phase is severely kinked. Different stress states have a great influence on dislocation slip, and the shear stress state can easily provoke the initiation of non-basal slip. Non-basal slip has difficulty starting under compressive stress, which leads to dislocation packing. The dynamic recrystallization (DRX) fraction of compressive stress deformation is higher than that of shear stress deformation. Shear and compressive stress deformation alloys activate different kinds of twinning. In shear stress deformed alloys, tensile twins usually occur in grains with a small basal slip Schmid factor (SF). However, compression twins are activated in the compressive stress deformation alloy and occur in grains with larger SF values. When the slip is not fully coordinated with the deformation, kinking and twining occur to coordinate the deformation.

An Investigation of the Deformation and Cracking Mechanism of Mg–1Al–12Y Alloys Based on In-Situ SEM/EBSD Slip Trace Analysis

Revealing the deformation behavior and microstructure evolution in Mg-12Y–1Al alloy during hot compression

Microstructural and texture evolution investigation of laser melting deposited TA15 alloy at 500?C using in-situ EBSD tensile test

Deformation Behavior of Mg-Y-Ni Alloys Containing Different Volume Fraction of LPSO Phase During Tension and Compression Through In-Situ Synchrotron Diffraction

In-situ and ex-situ investigation of deformation behaviors of a dual-phase Mg−Ni−Y alloy

Quantitative Investigation on the Slip/Twinning Activity and Cracking Behavior During Low-Cycle Fatigue of an Extruded Mg-3Y Sheet

Deformation Behavior of an Extruded Mg–Dy–Zn Alloy with Long Period Stacking Ordered Phase

Ex-situ EBSD investigation of the reduced c/a values and work hardening behavior in Mg-4Li-1Al-0.5Y alloy under hot compression

In-situ investigate on the microstructure evolution, deformation and fracture mechanism of Mg-Gd-Zn-Mn alloy with varies of LPSO volume fraction

Ex-situ EBSD Analysis of Yield Asymmetry, Texture and Twinning Development in Mg–5Li–3Al–2Zn Alloy During Tensile and Compressive Deformation

Effects of Nanoprecipitates and LPSO Structure on Deformation and Fracture Behaviour of High-Strength Mg-Gd-Y-Zn-Mn Alloys

Plastic Strain Accommodation and Crack Initiation in a Randomly-Oriented Mg-8y-1zr Magnesium Alloy During Accumulated Tensile Deformation

Enhanced Mechanical Properties of Mg-1Al-12Y Alloy Containing Long Period Stacking Ordered Phase

High Strain Rates Deformation Behavior of an As-Extruded Mg–2.5Zn–4Y Magnesium Alloy Containing LPSO Phase at High Temperatures

Quantitative Investigation on the Deformation Modes and Cracking Behavior During Cyclic Torsional Loading of Extruded Pure Mg and Mg-3y Alloy

Deformation mechanisms of basal slip, twinning and non-basal slips in Mg–Y alloy by micropillar compression

The Effect of LPSO on the Deformation Mechanism of Mg–Gd–Y–Zn–Zr Magnesium Alloy

Evolution of Deformation Substructure and MgxZnyCaz Metastable Phase in Fine-Grained Mg Alloys

Compressive stress and shear stress on the deformation mechanism of Mg-13Gd-4Y–2Zn-0.5Zr alloy at different deformation temperatures

In-situ Analysis of Slip Transfer and Heterogeneous Deformation in Tension of Mg-5.4Gd-1.8Y-1.5Zn Alloy

In-Situ Analysis of the Tensile Deformation Modes and Anisotropy of Extruded Mg-10gd-3y-0.5zr (wt.%) at Elevated Temperatures