Abstract:As we know, 3DPC is printed layer by layer compared with mold-casting conventional concrete. Pore structure and layer-to-layer interface are two main aspects of the internal structure for 3DPC, which decide 3DPC's mechanical performance. The layer-to-layer interface caused by printing is specific to 3DPC. The emphasis of this study lies in the layer-to-layer interfaces of 3DPC. The first aim of this study is to quantify the characteristics of the layer-to-layer interface and therefore characterize different aspects of the interfaces. The second aim of this study is to explore how the internal structure of printed concrete influences the mechanical performance of 3DPC. This research set out to design a series of experimental comparisons between 3DPC and casted concrete with the same compositions. Mechanical tests, i.e., compressive stress, ultrasonic Pulse Velocity test, flexural tension, and tension splitting, as well as the Ultrasonic Pulse Velocity test, were performed to check the mechanical performance of 3DPC. Contrary to what has often been expected, the mechanical test results showed the printed concrete has a quality not worse than casted concrete with the same recipe. Meanwhile, the X-ray computed tomography (X-CT) is used to characterize the internal structure, pore shapes, and interfaces of 3DPC. First, the investigation revealed that the lower total porosity and fewer big voids could be the fundamental causes meaning 3DPC has a better mechanical performance than casted concrete. Second, the statistics based on aspect ratio show that the distribution curves follow similar trends, regardless of the printed or casted concrete. Third, this study quantified the depth of the different interfaces for 3DPC. The results suggest that the porosity in an interface varies in a range. The author's pioneer work has contributed to our present understanding of the interfaces of 3DPC.

A Microscale-Based Numerical Model for Investigating Hygro-Thermo-mechanical Behaviour of 3D Printed Concrete at Elevated Temperatures

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

3-D Numerical Modelling of Mesoscopic Configuration and Cracking of Concrete

Microstructure and mechanical behaviour of 3D printed ultra-high performance concrete after elevated temperatures

Microstructural modeling of moisture-thermal and mechanical behavior within concrete during drying at elevated temperatures

2D and 3D homogenization and fracture analysis of concrete based on in-situ X-ray Computed Tomography images and Monte Carlo simulations

A Coupled Hygro-Thermal Model of Early-Age Concrete Based on Micro-Pore Structure Evolution

A novel multi-scale model for predicting the thermal damage of hybrid fiber-reinforced concrete

Study on Shear Behavior of Concrete-polymer Cement Mortar at Elevated Temperature

A review of recent trends and challenges in numerical modeling of the anisotropic behavior of hardened 3D printed concrete

Investigation on Concrete-Pcm Interface under Elevated Temperature: at Material Level and Member Level

A thermo-hygro computational model to determine the factors dictating cold joint formation in 3D printed concrete

Modeling and Mesoscale Simulation of Ice-Strengthened Mechanical Properties of Concrete at Low Temperatures

An improved micromechanical model for the thermal conductivity of multi-scale fiber reinforced ultra-high performance concrete under high temperatures

Thermo-Mechanistic Multi-Scale Modeling of Structural Concrete at High Temperature

3 D In-situ XCT Image Based Mesoscale Fracture Modelling and Validation of Concrete Using Voxel Hexahedron Meshing and Damage Plasticity Model

Multiscale Thermoelastic Analysis of the Thermal Expansion Coefficient and of Microscopic Thermal Stresses of Mature Concrete

3D concrete printing modelling of thin-walled structures

Numerical simulation of the freezing process of concrete

Assessing the Load-Bearing Capacity of 3D-Printed Concrete at Early Ages: An Innovative Approach