Abstract:There might be a three-layer molten pool configuration with a heavy metallic layer at the bottom in the stratified molten pool configuration. Because of the decay heat in the heavy metallic layer and the relatively low critical heat flux (CHF) at the bottom of the molten pool, vessel failure could occur at the sidewall adjacent to the heavy metallic layer. The heavy metallic layer experiment was carried out using Wood’s metal or water as the simulant to analyze the heat transfer of the heavy metallic layer under different boundary conditions. The experimental apparatus mainly contains the cooling water tank, pump, valve, test section, and watercooling heat exchanger. The different cooling rates could be obtained by adjusting the valves. Wood’s metal test has a top cooling and a sidewall cooling boundary conditions, and water tests have a top heated and a sidewall cooling boundary conditions. The sidewall cooling channels were used to simulate the external reactor vessel cooling (ERVC) conditions. A three-dimension hemisphere with a radius of 1.2 m was used as the test section, and the heavy metallic layer’s height was set to 0.3 m. Heating coils were installed in the test section to simulate the decay heat in the heavy metallic layer. Besides, thermocouples were inserted in the sidewall and test section to record the temperature data. The experimental results illustrate that the melt temperature in the heavy metallic layer increases with the height. Thermal stratification is evident in the heavy metallic layer, and heat convection is limited. But the normalized melt temperature along the horizontal direction tends to be constant. When no crust formation occurs, the water test results demonstrate that the sideward heat flux increases with the polar angle. However, when the crust formation occurs in the heavy metallic layer, Wood’s metal test results demonstrate that the dominant heat transfer mode would turn from the convective heat transfer to the heat conduction. It will affect the sideward heat flux distribution that is not constant for both heat transfer modes. Consequently, the sideward heat flux would decrease with the increase of the polar angle and the maximum sideward heat flux occurs in the bottom of the test section. By comparing the experimental sideward Nusselt number with the calculated results of previous correlations, it is found that the heat transfer correlations of ACOPO, BALI, Mayinger, and UCLA could reasonably predict the average sideward Nusselt number of the heavy metallic layer when Wood’s metal or water is the simulant.

Effect of metal layer height on heat transfer inside molten pool

Investigation on the Effect of Low Aspect Ratio on Heat Transfer Characteristics for Light Metallic Layer

Experimental Research of Heat Transfer in Heavy Metallic Layer under Different Top Boundary Conditions

Heat Transfer Experiment with the Prototypical Ra Number of Heavy Metallic Layer in IVR Strategy

Study on the Calculation Method of Molten Pool Decay Heat Distribution under IVR Condition

Experimental Investigation on Heat Transfer Characteristics of Oxide Layer of Molten Pool

Simulation Model for Investigating Safety Margin of Three-Layer Molten Pool after Late Phase In-Vessel Water Injection

A metal layer heat transfer behavior experiment to support CAP1400 IVR strategy

Research on Uncertainty Analysis of In-Vessel Retention Parameters in Advanced PWR

Different Heat Transfer Modes of Heavy Metallic Layer in IVR Strategy

Numerical study on the thermal hydraulic characteristics of ERVC system

Three-dimensional Experiment of Heat Transfer for Molten Oxidic Pool

Investigation on Three-Layer Coupled Molten Pool Heat Transfer Experiment with Three Different Materials

Effect of Different Conditions on Heat Transfer Characteristics of Molten Zr-Stainless Steel Pool with Water Injection

Heat transfer of film boiling on the molten metal after water injection

Effect of Grooves on Nucleate Boiling Heat Transfer from Downward Facing Hemispherical Surface

Numerical Investigation on the Thermal-Hydraulic Characteristics near a Corroded Lower Head of the Reactor Vessel During IVR-ERVC

Study on stable multi-layer molten pool experiment with internal heat generation in ERVC-IVR strategy

Experimental Research on Influence of Real Surface Material and Aging Effect on ERVC-CHF of RPV

Turbulent Convection Experiment at High Rayleigh Number to Support Cap1400 Ivr Strategy

Experimental Study on Heat Transfer Characteristics of Water Injection on Molten Pool with Low Mass Fraction of Zirconium