Effect of Nanometer WC Coating on Thermal Conductivity of Diamond/6061 Composites

Z. Y. Dong,D. Wang,W. G. Wang,B. L. Xiao,Z. Y. Ma

DOI: https://doi.org/10.1007/s40195-022-01450-2

2022-01-01

Abstract:Diamond has poor interface tolerance with Al. To enhance interface bonding, in this study, tungsten carbide (WC) nanocoatings on the surface of diamond particles were prepared using sol–gel and in-situ reaction methods. WO 3 sol–gel with two concentrations, 0.2 mol/L, and 0.5 mol/L, was, respectively, coated on diamond particles, then sintered at 1250 °C for 2 h to produce WC nanocoatings. The concentration of 0.2 mol/L WO 3 sol–gel was not enough to cover the surface of the diamond completely, while 0.5 mol/L WO 3 sol–gel could fully cover it. Moreover, WO 3 was preferentially deposited on {100} planes of the diamond. WO 3 converted to WC in-situ nanocoatings after sintering due to the in-situ reaction of WO 3 and diamond. The diamond-reinforced Al composites with and without WC coating were fabricated by powder metallurgy. The diamond/Al composite without coating has a thermal conductivity of 584.7 W/mK, while the composite with a coating formed by 0.2 mol/L and 0.5 mol/L WO 3 sol–gel showed thermal conductivities of 626.1 W/mK and 584.2 W/mK, respectively. The moderate thickness of nanocoatings formed by 0.2 mol/L WO 3 sol–gel could enhance interface bonding, therefore improving thermal conductivity. The nanocoating produced by 0.5 mol/L WO 3 sol–gel cracked during the fabrication of the composite, leading to Al 12 W formation and a decrease in thermal conductivity.