Synthesis of acrylic acid from methyl lactate over calcium phosphate catalysts in a fixed bed reactor: time-on-stream behavior and kinetic analysis

Atte Aho,Päivi Mäki-Arvela,Narendra Kumar,Ilari Angervo,Kari Eränen,Johan Wärnå,Tapio Salmi,Dmitry Yu Murzin
DOI: https://doi.org/10.1080/00986445.2024.2338787
2024-04-12
Chemical Engineering Communications
Abstract:Transformation of methyl lactate to acrylic acid was investigated over Ca 3 (PO 4 ) 2 , Ca 2 (P 2 O 7 ) and their mixture in the temperature range of 250-425 °C. The initial concentration of methyl lactate in water was varied from 2 wt% to neat methyl lactate. The results showed that these phosphate catalysts did not contain any measurable amounts of either acid sites or basic sites. The best catalyst was Ca 3 (PO 4 ) 2 giving 62% selectivity to acrylic acid at 75% conversion at 400 °C using GHSV of 95280 h −1 and 2 wt% methyl lactate in the initial feed. This catalyst exhibited larger surface area in comparison to Ca 2 (P 2 O 7 ). Elemental analysis revealed that some Ca leaching occurred during reaction, while in case of Ca 2 (P 2 O 7 ) the calcium leaching was 3.4 fold higher than observed for Ca 3 (PO 4 ) 2 . Long-term results over Ca 3 (PO 4 ) 2 showed that extensive catalyst deactivation occurred during the first 11 h time-on-stream, after which the activity dropped only slightly. In addition to kinetic studies with different parameters, also, kinetic modeling was performed and the activation energies for formation of different products were determined over different catalysts.
engineering, chemical
What problem does this paper attempt to address?