Abstract:PURPOSE Upon irradiation the active diacetylene layer of radiochromic films undergoes dose-dependent polymerization in the blue polydiacetylene form. Dose assessment is currently based on linear absorbance measurements. The scope of the present study was designed for the further understanding of the linear and, in particular, the nonlinear optical characteristics of such films and the utilization of these characteristics for devising alternative "reading" procedures. METHODS The nonlinear optical interactions of laser light with previously irradiated GafChromic(®) HD-810 and MD55-2 films were studied by z-scan techniques. The focused laser beam strikes on the film, which is located at various distances from the focal spot. The beam induces linear and nonlinear absorption and refraction. The measurement of the transmitted power (open-aperture z-scan) allows the study of the nonlinear absorption. On the other hand, the measurement of the axial region of the transmitted beam (closed-aperture z-scan) is related to both nonlinear absorption and refraction effects. A 10 mW, 633 nm, linearly polarized He/Ne laser was employed as the light source. The transmittance measurements were coupled with absorbance measurements carried out over the whole visible spectrum and at various reading temperatures, in an attempt to clarify the underlying mechanisms dictating the observed effects. These effects were incorporated to an open-aperture z-scan model, developed for the purpose of comparison to the corresponding experimental curves. RESULTS The transmittance data obtained by both open- and closed-aperture z-scan were found to be dose-dependent, thus allowing such transmittance techniques to be employed for dose assessment. Low power open-aperture z-scan measurements (sensitive to absorptive nonlinearities) revealed a stepwise two-photon excitation of the active layer, through an intermediate state. At higher laser intensities (and/or absorbed dose), the shapes of the z-scan curves were found to be more complicated. These shapes were attributed to a temperature-dependent (thermochromic) transition from the blue form to the conformer red form of the active material, a transition which appears to be irreversible at high intensities. This transition was incorporated into the open-aperture z-scan model which reproduced satisfactorily the corresponding experimental curves. Finally, the use of a chopped laser beam in the closed-aperture z-scan technique allowed artifact-free, high spatial resolution dose measurements using a laser beam of relatively high power. CONCLUSIONS The model developed in the present study elucidates some of the effects related to film reading and the causes of some of the artifacts reported in the literature. Two-dimensional dose distributions can be assessed by z-scan; however, the merits of such a technique relative to those currently in use have to be further investigated.

Facile Optimization of Grafted Chain Length on Antifouling Properties Based on Hyperbranched Polyglycerol

Antifouling Surfaces Based on Fluorine-Containing Asymmetric Polymer Brushes: Effect of Chain Length of Fluorinated Side Chain.

Surface immobilization of polymer brushes onto porous poly(vinylidene fluoride) membrane by electron beam to improve the hydrophilicity and fouling resistance

Grafting density and antifouling properties of poly[N-(2-hydroxypropyl) methacrylamide] brushes prepared by “grafting to” and “grafting from”

Porous membranes modified by hyperbranched polymers II.Effect of the arm length of amphiphilic hyperbranched-star polymers on the hydrophilicity and protein resistance of poly(vinylidene fluoride) membranes

[Effect of uranyl ion on intestinal absorption of glucose].

Achieving highly effective non-biofouling performance for polypropylene membranes modified by UV-induced surface graft polymerization of two oppositely charged monomers.

Enhancing Membrane Surface Antifouling by Implanting Amphiphilic Polymer Brushes Using a Swelling Induced Entrapment Technique.

Antifouling coating of membrane surface with branched poly(2-hydroxyethyl acrylate) brushes via aqueous reversible deactivation radical polymerization

John C Reeder--Director of the Papua New Guinea Institute of Medical Research. Interview by Pam Das.

Fouling Control In A Submerged Membrane-Bioreactor By The Membrane Surface Modification

Grafting embedded poly(ionic liquid) brushes on biomimetic sharklet resin surface for anti-biofouling applications

Mixed Polymer Brushes with Integrated Antibacterial and Antifouling Properties

Experimental and theoretical investigation of chain length and surface coverage on fouling of surface grafted polypeptoids

Zwitterionic polymer brush-functionalized dual-crosslinked hydrogel via subsurface-initiated atom transfer radical polymerization for anti-fouling applications

PEG-functionalized aliphatic polycarbonate brushes with self-polishing dynamic antifouling properties

Multiscale Hairy Surfaces for Nearly Perfect Marine Antibiofouling

Molecular simulations and understanding of antifouling zwitterionic polymer brushes.

Improving the biofouling resistance of polyamide thin-film composite membrane via grafting polyacrylamide brush on the surface by in-situ atomic transfer radical polymerization

Thermochromic phase-transitions of GafChromic films studied by z-scan and temperature-dependent absorbance measurements.

Computational Investigation of Antifouling Property of Polyacrylamide Brushes